Silicon oxide atomic layer deposition synthesis development over the last few years has open the route to its use as a dielectric within diamond electronics. Its great band-gap makes it a promising material for the fabrication of diamond–metal–oxide field effects transistor gates. Having a sufficiently high barrier both for holes and electrons is mandatory to work in accumulation and inversion regimes without leakage currents, and no other oxide can fulfil this requisite due to the wide diamond band-gap. In this work, the heterojunction of atomic-layer-deposited silicon oxide and (100)-oriented p-type oxygen-terminated diamond is studied using scanning transmission electron microscopy in its energy loss spectroscopy mode and X-ray photoelectron spectroscopy. The amorphous phase of silicon oxide was successfully synthesized with a homogeneous band-gap of 9.4 eV. The interface between the oxide and diamond consisted mainly of single- and double-carbon-oxygen bonds with a low density of interface states and a straddling band setting with a 2.0 eV valence band-offset and 1.9 eV conduction band-offset.
The thermal atomic layer deposition (ThALD) of yttrium oxide (Y2O3) was developed using the newly designed, liquid precursor, Y(EtCp)2(iPr2-amd), as the yttrium source in combination with different oxygen sources, such as ozone, water and even molecular oxygen. Saturation was observed for the growth of the Y2O3 films within an ALD window of 300 to 450 °C and a growth per cycle (GPC) up to 1.1 Å. The resulting Y2O3 films possess a smooth and crystalline structure, while avoiding any carbon and nitrogen contamination, as observed by X-ray photoelectron spectroscopy (XPS). The films showed strong resistance to fluorine-containing plasma, outperforming other resistant materials, such as silicon oxide, silicon nitride and alumina. Interestingly, the hydrophilic character exhibited by the film could be switched to hydrophobic after exposure to air, with water contact angles exceeding 90°. After annealing under N2 flow at 600 °C for 4 min, the hydrophobicity was lost, but proved recoverable after prolonged air exposure or intentional hydrocarbon exposure. The origin of these changes in hydrophobicity was examined.
The effects of nitrosyl fluoride (FNO) gas treatment on the surface of GaN(0001) and its interface with sputtered Pt were investigated by hard x-ray photoelectron spectroscopy (HAXPES). Annealing GaN and Pt/GaN samples in an FNO gas atmosphere resulted in the appearance of prominent F 1s peaks in the HAXPES spectra, indicating the efficient formation of Ga–Fx bonding states not only in bare-GaN but also in Pt/GaN, even when the FNO gas treatment was performed after Pt deposition. In addition, the chemical shifts of the Ga 2p3/2 and N 1s peaks corresponded to a Fermi level shift toward the valence band. The FNO gas treatment induced greater oxidation of the GaN surface than the Pt/GaN interface. By contrast, at the Pt/GaN interface, the unintentionally formed oxide GaOx was reduced, resulting in an improvement of the electrical properties. The results of this study suggest that FNO gas treatment is an effective post-processing method for the fluorination of GaN-based systems after metal deposition.