Laser powder bed fusion (L-PBF) was used to produce stator half-shells of a transverse flux machine from pure iron (99.9% Fe). In order to reduce iron losses in the bulk components, radially extending slits with a nominal width of 150 and 300 µm, respectively, were integrated during manufacturing. The components were subjected to a suitable heat treatment. In addition to a microscopic examination of the slit quality, the iron losses were also measured using both a commercial and a self-developed measurement setup. The investigations showed the iron losses can be reduced by up to 49% due to the integrated slits and the heat treatment.

This article focuses on increasing the computational efficiency of 3D multi-static magnetic finite element analysis (FEA) for electrical machines (EMs), which have a magnetic field evolving in 3D space. Although 3D FEA is crucial for analyzing these machines and their operational behavior, it is computationally expensive. A novel approach is proposed in order to solve the magnetic field equations by exclusively using the magnetic scalar potential. For this purpose, virtual variable permanent magnets (vPMs) are introduced to model the impact of the machine’s coils. The effect on which this approach is based is derived from and explained by Maxwell’s equations. To validate the new approach, an axial flux machine (AFM) is simulated using both 2D and 3D FEA with the magnetic vector potential and current-carrying coils as a reference. The results demonstrate a high level of agreement between the new approach and the reference simulations as well as an acceleration of the computation by a factor of 15 or even more. Additionally, the research provides valuable insights into meshing techniques and torque calculation for EMs in FEA.

This article presents a prototype of a planar aligned transverse flux machine with spatially distributed phases. This topology enables a flatter assembly space compared to typical transverse flux machines and, additionally, features a reduction gear. This makes it a suitable solution for low-speed high-torque applications primarily found in medical or industrial robotic surroundings. The exemplary motor is described throughout its design process and evaluated in detail in simulations and measurements. Benefits and challenges of the concept are considered and presented.

Generators in wind turbines are the key components to convert mechanical into electrical power. They are subject to electrical and mechanical excitation at the same time, which can cause electro-mechanical interactions. To avoid unwanted interactions, standard design approaches use conservative, stiff designs that lead to heavy generators of several hundred tons. New wind turbine designs, beyond 10 MW, need to revisit the conservative design approach as the tower top mass needs to be limited. To reduce the generator’s mass without large deformation that can damage the wind turbine, a better understanding of electro-mechanical interactions is key. This requires a detailed model including both the mechanical and the magnetic forces. This work presents a numerical setup of a coupled electromagnetic-structural multi-body model. While existing couplings are application-specific; the presented coupling is independent of the actual use case and allows for transient dynamic two-way coupled analyses. For validation, an experimental setup with basic components is introduced. The results show the applicability of the developed coupling for detailed analysis of general electro-mechanical interactions.