Thermoelectrics enable waste heat recovery, holding promises in relieving energy and environmental crisis. Lillianite materials have been long-term ignored due to low thermoelectric efficiency. Herein we report the discovery of superior thermoelectric performance in Pb7Bi4Se13 based lillianites, with a peak figure of merit, zT of 1.35 at 800 K and a high average zT of 0.92 (450–800 K). A unique quality factor is established to predict and evaluate thermoelectric performances. It considers both band nonparabolicity and band gaps, commonly negligible in conventional quality factors. Such appealing performance is attributed to the convergence of effectively nested conduction bands, providing a high number of valley degeneracy, and a low thermal conductivity, stemming from large lattice anharmonicity, low-frequency localized Einstein modes and the coexistence of high-density moiré fringes and nanoscale defects. This work rekindles the vision that Pb7Bi4Se13 based lillianites are promising candidates for highly efficient thermoelectric energy conversion.
Low cost magnetocaloric nanomaterials have attracted considerable attention for energy efficient applications. We report a very high relative cooling power (RCP) in a study of the magnetocaloric effect in quenched FeNiB nanoparticles. RCP increases from 89.8 to 640 J kg−1 for a field change of 1 and 5 T, respectively, these values are the largest for rare earth free iron based magnetocaloric nanomaterials. To investigate the magnetocaloric behavior around the Curie temperature (TC), the critical behavior of these quenched nanoparticles was studied. Detailed analysis of the magnetic phase transition using the modified Arrott plot, Kouvel-Fisher method, and critical isotherm plots yields critical exponents of β = 0.364, γ = 1.319, δ = 4.623, and α = −0.055, which are close to the theoretical exponents obtained from the 3D-Heisenberg model. Our results indicate that these FeNiB nanoparticles are potential candidates for magnetocaloric fluid based heat pumps and low grade waste heat recovery.
We have investigated magnetization (M), magnetocaloric effect (MCE), and magnetothermopower (MTEP) in polycrystalline Pr0.6Sr0.4MnO3, which shows a second-order paramagnetic to ferromagnetic transition near room temperature (TC = 305 K). However, field-cooled M(T) within the long range ferromagnetic state shows an abrupt decrease at TS = 86 K for μ0H < 3 T. The low temperature transition is first-order in nature as suggested by the hysteresis in M(T) and exothermic/endothermic peaks in differential thermal analysis for cooling and warming cycles. The anomaly at TS is attributed to a structural transition from orthorhombic to monoclinic phase. The magnetic entropy change (ΔSm = Sm(μ0H)-Sm(0)) shows a negative peak at TC (normal MCE) and a positive spike (inverse MCE) at TS. ΔSm = −2.185 J/kg K (−3.416 J/kg K) with refrigeration capacity RC = 43.4 J/kg (103.324 J/kg) for field change of μ0ΔH = 1.5 T (3 T) at TC = 304 K is one of the largest values reported in manganites near room temperature. Thermopower (Q) is negative from 350 K to 20 K, which shows a rapid decrease at TC and a small cusp around TS in zero field. The MTEP [ΔQ/Q(0)] reaches a maximum value of 25% for μ0ΔH = 3 T around TC, which is much higher than 15% dc magnetoresistance for the same field change. A linear relation between MTEP and magnetoresistance and between ΔSm and ΔQ are found near TC. Further, ac magnetotransport in low dc magnetic fields (μ0H ≤ 0.1 T), critical analysis of the paramagnetic to ferromagnetic transition, and scaling behavior of ΔSm versus a reduced temperature under different magnetic fields are also reported. Coexistence of large magnetic entropy change and magnetothermopower around room temperature makes this compound interesting for applications.