Yutaro Akimoto

Dr. Yutaro Akimoto

orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 November 2022 in Sustainable Horizons
Verified
Journal Article
Open access
NKNor Hazlina Md Khairi
Nor Hazlina Md Khairi
YAYutaro Akimoto
Yutaro Akimoto
KOKeiichi Okajima
Keiichi Okajima

29 May 2022 in Energies
Verified
Journal Article
Open access
PDF file
Abdulrahman JoubiAbdulrahman Joubi
Abdulrahman Joubi
YAYutaro Akimoto
Yutaro Akimoto
KOKeiichi Okajima
Keiichi Okajima
Hydrogen production from surplus solar electricity as energy storage for export purposes can push towards large-scale application of solar energy in the United Arab Emirates and the Middle East region; this region’s properties of high solar irradiance and vast empty lands provide a good fit for solar technologies such as concentrated solar power and photovoltaics. However, a thorough comparison between the two solar technologies, as well as investigating the infrastructure of the United Arab Emirates for a well-to-ship hydrogen pathway, is yet to be fully carried out. Therefore, in this study we aim to provide a full model for solar hydrogen production and delivery by evaluating the potential of concentrated solar power and photovoltaics in the UAE, then comparing two different pathways for hydrogen delivery based on the location of hydrogen production sites. A Solid Oxide Cell Electrolyzer (SOEC) is used for technical comparison, while the shortest routes for hydrogen transport were analyzed using Geographical Information System (GIS). The results show that CSP technology coupled with SOEC is the most favorable pathway for large-scale hydrogen from solar energy production in the UAE for export purposes. Although PV has a slightly higher electricity potential compared to CSP, around 42 GWh/km2 to 41.1 GWh/km2, respectively, CSP show the highest productions rates of over 6 megatons of hydrogen when the electrolyzer is placed at the same site as the CSP plant, while PV generates 5.15 megatons when hydrogen is produced at the same site with PV plants; meanwhile, hydrogen from PV and CSP shows similar levels of 4.8 and 4.6 megatons of hydrogen, respectively, when electrolyzers are placed at port sites. Even considering the constraints in the UAE’s infrastructure and suggesting new shorter electrical transmission lines that could save up to 0.1 megatons of hydrogen in the second pathway, production at the same site with CSP is still the most advantageous scenario.

10 October 2022 in Hydrogen
Verified
Journal Article
Open access
PDF file
Abdulrahman JoubiAbdulrahman Joubi
Abdulrahman Joubi
YAYutaro Akimoto
Yutaro Akimoto
KOKeiichi Okajima
Keiichi Okajima
Solar thermal technology can provide the United Arab Emirates and the Middle East region with abundant clean electricity to mitigate the rising levels of carbon dioxide and satisfy future demand. Hydrogen can play a key role in the large-scale application of solar thermal technologies, such as concentrated solar plants, in the region by storing the surplus electricity and exporting it to needed countries for profit, placing the Middle East and the United Arab Emirates as major future green hydrogen suppliers. However, a hydrogen supply chain comparison between hydrogen from CSP and other renewable under the UAE’s technical and economic conditions for hydrogen export is yet to be fully considered. Therefore, in this study we provide a techno-economic analysis for well-to-ship solar hydrogen supply chain that compares CSP and PV technologies with a solid oxide water electrolyzer for hydrogen production, assuming four different hydrogen delivery pathways based on the location of electrolyzer and source of electricity, assuming the SOEC can be coupled to the CSP plant when placed at the same site or provided with electric heaters when placed at PV plant site or port sites. The results show that the PV plant achieves a lower levelized cost of electricity than that of the CSP plant with 5.08 ¢/kWh and 8.6 ¢/kWh, respectively. Hydrogen production results show that the scenario where SOEC is coupled to the CSP plant is the most competitive scenario as it achieves the payback period in the shortest period compared to the other scenarios, and also provides higher revenues and a cheaper LCOH of 7.85 $/kgH2.

1 November 2020 in Energy Reports
Verified
Journal Article
Open access
YAYutaro Akimoto
Yutaro Akimoto
HTHinato Takezawa
Hinato Takezawa
YIYosuke Iijima
Yosuke Iijima
SSShin-Nosuke Suzuki
Shin-Nosuke Suzuki
KOKeiichi Okajima
Keiichi Okajima

1 January 2019 in Procedia Computer Science
Verified
Journal Article
Open access
SSShin-Nosuke Suzuki
Shin-Nosuke Suzuki
YAYutaro Akimoto
Yutaro Akimoto
KHKatsumi Hirata
Katsumi Hirata
MIManabu Ishihara
Manabu Ishihara
RKRyohei Kameyama
Ryohei Kameyama
KYKuniaki Yajima
Kuniaki Yajima

1 January 2014 in Energy Technology & Policy
Verified
Journal Article
Open access
YAYutaro Akimoto
Yutaro Akimoto
KOKeiichi Okajima
Keiichi Okajima
The characteristic of a proton exchange membrane fuel cell is shown by the relationship between its output voltage and current. The output cell voltage determines the activation loss, ohmic loss, and concentration loss. Studying these losses is important to understand their effect of the reduction factor of the output of the fuel cell. One method of calculating these losses is by the curve-fitting using a semi-empirical equation. This method is useful for quickly predicting the performance. In previous studies, the fuel cell temperature has been assumed to be steady. However, the operation temperature of the fuel cell is not constant in the real fuel cell systems, such as residential and vehicular fuel-cell stacks. Therefore, it is difficult to separate the different types of losses on a polarization curve. In this study, we propose a new semi-empirical equation considering the fuel cell’s operation temperature. Through thermodynamic, mechanistic, and electrochemical modeling, we express the initial voltage, activation loss, ohmic loss, and the concentration loss. We compare the fitting parameters of the proposed equation with those of equations proposed in previous studies. We also study the effects of operating temperature and cathode gas on the parameters that influence the performance.