Hydrogen production from surplus solar electricity as energy storage for export purposes can push towards large-scale application of solar energy in the United Arab Emirates and the Middle East region; this region’s properties of high solar irradiance and vast empty lands provide a good fit for solar technologies such as concentrated solar power and photovoltaics. However, a thorough comparison between the two solar technologies, as well as investigating the infrastructure of the United Arab Emirates for a well-to-ship hydrogen pathway, is yet to be fully carried out. Therefore, in this study we aim to provide a full model for solar hydrogen production and delivery by evaluating the potential of concentrated solar power and photovoltaics in the UAE, then comparing two different pathways for hydrogen delivery based on the location of hydrogen production sites. A Solid Oxide Cell Electrolyzer (SOEC) is used for technical comparison, while the shortest routes for hydrogen transport were analyzed using Geographical Information System (GIS). The results show that CSP technology coupled with SOEC is the most favorable pathway for large-scale hydrogen from solar energy production in the UAE for export purposes. Although PV has a slightly higher electricity potential compared to CSP, around 42 GWh/km2 to 41.1 GWh/km2, respectively, CSP show the highest productions rates of over 6 megatons of hydrogen when the electrolyzer is placed at the same site as the CSP plant, while PV generates 5.15 megatons when hydrogen is produced at the same site with PV plants; meanwhile, hydrogen from PV and CSP shows similar levels of 4.8 and 4.6 megatons of hydrogen, respectively, when electrolyzers are placed at port sites. Even considering the constraints in the UAE’s infrastructure and suggesting new shorter electrical transmission lines that could save up to 0.1 megatons of hydrogen in the second pathway, production at the same site with CSP is still the most advantageous scenario.
Solar thermal technology can provide the United Arab Emirates and the Middle East region with abundant clean electricity to mitigate the rising levels of carbon dioxide and satisfy future demand. Hydrogen can play a key role in the large-scale application of solar thermal technologies, such as concentrated solar plants, in the region by storing the surplus electricity and exporting it to needed countries for profit, placing the Middle East and the United Arab Emirates as major future green hydrogen suppliers. However, a hydrogen supply chain comparison between hydrogen from CSP and other renewable under the UAE’s technical and economic conditions for hydrogen export is yet to be fully considered. Therefore, in this study we provide a techno-economic analysis for well-to-ship solar hydrogen supply chain that compares CSP and PV technologies with a solid oxide water electrolyzer for hydrogen production, assuming four different hydrogen delivery pathways based on the location of electrolyzer and source of electricity, assuming the SOEC can be coupled to the CSP plant when placed at the same site or provided with electric heaters when placed at PV plant site or port sites. The results show that the PV plant achieves a lower levelized cost of electricity than that of the CSP plant with 5.08 ¢/kWh and 8.6 ¢/kWh, respectively. Hydrogen production results show that the scenario where SOEC is coupled to the CSP plant is the most competitive scenario as it achieves the payback period in the shortest period compared to the other scenarios, and also provides higher revenues and a cheaper LCOH of 7.85 $/kgH2.
Since China is the largest CO2emitting country in the world, photovoltaic (PV) systems are expected to be widely installed to reduce CO2emission. In general, available area for PV installation depends on urban area due to differences in land use and slope. Amount of electricity generated by a PV system also depends on urban area because of differences in solar irradiation and ambient temperature. The aim of this study is to evaluate the installation of large-scale PV systems in suburbs of China, taking these differences into consideration. We have used a geographic information system (GIS) to evaluate amounts of installation capacity of large-scale PV systems, electricity generated, and CO2emission reduction by the installation capacity of large-scale PV systems in suburbs of Liaoning, Shanghai, Anhui, and Guangdong. In Liaoning, the amount of CO2emission reduction by the installation capacity of large-scale PV systems was estimated to be the largest, 3,058 kt-CO2/yr, due to its larger amount of the installation capacity, 2439.4 MW, than the amount of the installation capacity in other regions.
23 August 2025 in Journal of Environmental Management
For a low-carbon society, it is necessary to extract hydrogen for fuel cells from biogas rather than from fossil fuels. However, impurities contained in the biogas affect the fuel cell; hence, there is a need for system and operation methods to remove these impurities. In this study, to develop a fuel cell system for the effective utilization of biogas-derived hydrogen, the compositional change and concentration of impurities in the hydrogen recirculation system under actual operation were evaluated using process simulation. Then, the mitigation operation for performance degradation using simple purification methods was evaluated on the proton exchange membrane fuel cells (PEMFC) stack. In the process simulation of the hydrogen recirculation system, including the PEMFC stack, the concentration of impurities remained at a level that did not pose a problem to the performance. In the constant voltage test for a simulated gas supply of biogas-derived hydrogen, the conditions for applying the methanation reforming and air bleeding methods were analyzed. As a result, methanation reforming is more suitable for supplying biogas-containing CO to the PEMFC stack for continuous operation.
Many countries are adopting renewable energy (RE) and electric vehicles (EVs) to achieve net-zero emissions by 2050. The indicators of RE and EV potentials are different. Decision-makers want to introduce RE and EVs; however, they need a method to find suitable areas. In addition, this is required in the time-series analysis to provide a detailed resolution. In this study, we conducted a time-series analysis in Japan to evaluate suitable areas for the combined use of RE and EVs. The results showed the surplus RE areas and shortage RE urban areas. The time-series analysis has quantitatively shown that it is not enough to charge EV batteries using surplus RE. Moreover, a ranking methodology was developed for the evaluation based on electric demand and vehicle numbers. This enables the government’s prioritization of prefectures and the prefectures’ prioritization of municipalities according to their policies.