Karina Schuldt

Ms. Karina Schuldt


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 June 2018 in Membranes
Verified
Journal Article
Open access
PDF file
KSKarina Schuldt
Karina Schuldt
JPJan Pohlmann
Jan Pohlmann
Sergey ShishatskiySergey Shishatskiy
Sergey Shishatskiy
Torsten  Brinkmann Torsten Brinkmann
Torsten Brinkmann
The PolyActive™ thin film composite membrane (TFCM) has already been successfully applied for CO2 separation tasks at feed pressures up to 10 bar. To investigate the applicability at higher pressures, measurements were undertaken with C2H4 containing gas mixtures with a composition comparable to the product stream of the oxidative coupling of methane process, as well as single gases up to a feed pressure of 30 bar. Furthermore, the permeances of the conducted gas mixture experiments were simulated. The results show a strong swelling influence of CO2 on the used membrane depending on the CO2 fugacity. This swelling effect leads to a pronounced decrease in selectivity. The observed membrane behavior at high pressures could not be predicted by the Free Volume Model (FVM). Two different simulations were conducted: one based on parameters calculated from single gas data measured at pressures up to 2 bar; and a second based on parameters calculated from single gas data measured at pressures from 2 to 30 bar. The two simulations differ in their prediction accuracy. However, they confirm that it is possible to predict the measured permeances in the pressure range up to an average CO2 fugacity of 6 bar.

21 April 2021 in Processes
Verified
Journal Article
Open access
PDF file
KSKarina Schuldt
Karina Schuldt
TBTorsten Brinkmann
Torsten Brinkmann
Prokopios GeorgopanosProkopios Georgopanos
Prokopios Georgopanos
The sustainable design of separation and polymer synthesis processes is of great importance. Therefore, an energy-efficient process for the purification of tetrahydrofuran (THF)–water (H2O) solvent mixtures from an upstream polymer synthesis process in pilot scale was developed with the aim to obtain high purity separation products. The advantages and limitations of a hybrid process in the pilot scale were studied utilizing an Aspen Plus Dynamics® simulation at different pressures to prove the feasibility and energy efficiency. For the rough separation of the two components, distillation was chosen as the first process step. In this way, a separation of a water stream of sufficient quality for further precipitations after polymer synthesis could be achieved. In order to overcome the limitations of the distillation process posed by the azeotropic point of the mixture, a vapor permeation is used, which takes advantage of the heat of evaporation already used in the distillation column. For the purpose of achieving the required low water contents, an adsorption column is installed downstream for final THF purification. This leads to a novel hybrid separation process that is energy efficient and thus allows also the use of the solvents again for upstream polymer synthesis achieving the high purity requirements in a closed-loop process.