The main problem for the application of hydrogen generated via hydrolysis of metal alloys is the low hydrogen generation rate (HGR). In this paper, active Al alloys were prepared using a new coupled method-melting-mechanical crushing-mechanical ball milling method to enhance the HGR at room temperature. This method contains three steps, including the melting of Al, Ga, In, and Sn ingots with low melting alloy blocks and casting into plates, then crushing alloy plate into powders and ball milling with chloride salts such as NiCl2 and CoCl2 were added during the ball milling process. The microstructure and phase compositions of Al alloys and reaction products were investigated via X-ray diffraction and scanning electron microscopy with energy dispersed X-ray spectroscopy. The low-melting-point Ga-In -Sn (GIS) phases contain a large amount of Al can act as a transmission medium for Al, which improves the diffusion of Al to Al/H2O reaction sites. Finer GIS phases after ball milling can further enhance the diffusion of Al and thus enhance the activity of Al alloy. The hydrogen generation performance through hydrolysis of water with Al at room temperature was investigated. The results show that the H2 generation performance of the Al-low-melting point alloy composite powder is significantly higher than the results reported to date. The highest H2 generation rate and H2 conversion efficiency can reach 5337 mL·min−1·g−1 for the hydrolysis of water with 1 g active alloy.
High hydro-active Al-3Ga-3In-3Sn alloys were prepared by coupling alloying and mechanical milling methods. NiCl2 was added to the alloy during ball milling as the catalyst. XRD, SEM, and XAFS were used for the characterization of the hydro-active alloy. The hydrogen generation properties were systematically investigated in tap water at room temperature. The results show that the hydrogen generation rate is 11.02 L∙min−1∙g−1, and the conversion yield is 90.25% for the Al-3Ga-3In-3Sn-2NiCl2 composite with a ball milling time of 2 h at room temperature in tap water. The hydrolysis reaction contains the expansion of the Al-based phase into a nano-sized layer and the further hydrolysis reaction of the layered Al phase with water. The activation mechanism was also investigated, and the activation of Al was attributed to the Al-Ni galvanic with the existing Cl−, which leads to a faster hydrolysis reaction rate for ball-milled powder with NiCl2.
Magnesium has bright market prospects such as generating thrust for under water engines and hydrogen production. However, the passive oxide film on the surface of magnesium powder prevents the further reaction of magnesium with water at room temperature. In this paper, highly active magnesium-based materials were prepared via ball milling pure Mg with different chlorides (NiCl2, CoCl2, CuCl2, FeCl3). The activity of the as obtained powder was analyzed through Scanning Electron Microscopy (SEM), Energy dispersive X-ray spectroscopy (EDS), X-ray photoelectron spectroscopy (XPS), synchrotron X-ray tomography, Extended X-ray Absorption Fine Structure (EXAFS), etc. Among the various compositions, the Mg-6%CoCl2 composite exhibited the best hydrogen production performance with a hydrogen generation volume of 423 mL/(0.5 g) and a conversion yield of 96.6%. The related activation mechanism was thoroughly studied, showing that the addition of chloride during ball milling can effectively break the continuity of oxide films on Mg surfaces and introduces a large number of micro defects. In addition, the EXAFS and tomography data verified that metallic cobalt was generated during the ball milling process, subsequently forming a Mg-Co micro glance cell, and the Cl− in the system accelerates the corrosion of Mg. The active mechanism can be verified as synergistic effects of micro glance cell and as-generated surface microcracks.