Magnetic shape memory effect or magnetically induced structure reorientation (MIR) occurred down to 1.7 K in 10 M martensite with composition of Ni50.0Mn27.5Ga22.5 exhibiting no intermartensite transformation. The reorientation of the martensite microstructure was mediated by the motion of single Type II twin boundary. In contrast with weak thermal dependence of Type II boundary, MIR with Type I boundary in the same alloy showed strong thermal dependence resembling normal thermal activation process and the effect disappeared below 220 K. Thus the type of the boundary is decisive for MIR at low temperatures.
Intermartensite transformations (IMTs) and temperature dependence of very low twinning stress associated with Type II twin boundaries were studied experimentally in four magnetic shape memory alloys with composition Ni50Mn25 + xGa25 – x (at. %), where x was between 3.2 and 3.9. The slightly different x or Mn content resulted in slightly different martensite transformation temperatures between 309 and 328 K, but in significantly different intermartensite transformation temperatures between 10 K and 251 K, with the transformation temperature being approximately proportional to x. In all four alloys, the initial twinning stress, about 0.1 MPa at room temperature, increases sharply when approaching the IMT at lower temperatures, up to 1 MPa and more. The effect is explained by the instability of 10M martensite near the IMT from which it follows that the twinning stress dependence shall be flat for . That is experimentally confirmed by an additional measurement on Ni50Mn27.7Ga22.3 alloy (x = 2.7), which exhibits just slowly increasing twinning stress with decreasing temperature, with the maximum of only 0.2 MPa at 1.7 K.
22 December 2015 in Smart Materials and Structures
In search of the origins of the extraordinary low twinning stress of Ni-Mn-Ga 10M martensite, we studied the temperature induced changes in lattice parameters of Ni 50 Mn
25+
x Ga
25−
x ( x = 2.7–3.9) single crystal samples and compared them with twinning stress dependences. The alloys exhibited transformation to five-layered (10M) martensite structure (cubic to monoclinic) between 297 to 328 K and exhibited the magnetic shape memory effect in martensite. The structural changes were monitored using x-ray diffraction in the temperature range 200–343 K. The 10M structure was approximated by monoclinic lattice, a = b > c , γ > 90° with the coordinates derived from the cubic unit cell of the parent L2 1 phase. The lattice parameters γ and c / a correlate well with the universal linear increase of twinning stress of type 1 twins with decreasing temperature. On the contrary, the twinning stress is not affected by differences between a and b and thus a / b twins seem to play no role in a − c twin boundary motion resulting in magnetically induced reorientation.
Systematic doping by transition elements Fe, Co and Ni on each site of Ni2MnGa alloy reveal that in bulk material the increase in martensitic transformation temperature is usually accompanied by the decrease in ferromagnetic Curie temperature, and vice versa. The highest martensitic transformation temperature (571 K) was found for Ni50.0Mn25.4(Ga20.3Ni4.3) with the result of a reduction in Curie temperature by 55 K. The highest Curie point (444 K) was found in alloy (Ni44.9Co5.1)Mn25.1Ga24.9; however, the transition temperature was reduced to 77 K. The dependence of transition temperature is better scaled with the Ne/a parameter (number of non-bonding electrons per atom) compared to usual e/a (valence electrons per atom). Ne/a dependence predicts a disappearance of martensitic transformation in (Ni45.3Fe5.3)Mn23.8Ga25.6, in agreement with our experiment. Although Curie temperature usually slightly decreases while the martensitic transition increases, there is no significant correlation of Curie temperature with e/a or Ne/a parameters. The doping effect of the same element is different for each compositional site. The cascade substitution is discussed and related to the experimental data.
22 September 2016 in Shape Memory and Superelasticity