The amplitude of the signal collected from the PbWO4crystals of the CMS electromagnetic calorimeter is reconstructed by a digital filtering technique. The amplitude reconstruction has been studied...

Low-power design looks for low-energy BIST. This paper considers the problem of minimizing the energy required to test a BISTed combinational circuit without modifying the stuck-at fault coverage and with no extra area or delay overhead over the classical LFSR architectures. The objective of this paper is twofold. First, is to analyze the impact of the polynomial and seed selection of the LFSR used as TPG on the energy consumed by the circuit. It is shown that appropriately selecting the seed of the LFSR can lead to an important energy reduction. Second, is to propose a method to significantly decrease the energy consumption of BIST sessions. For this purpose, a heuristic method based on a simulated annealing algorithm is briefly described in this paper. Experimental results using the ISCAS benchmark circuits are reported, showing variations of the weighted switching activity ranging from 147% to 889% according to the seed selected for the LFSR. Note that these results are always obtained with no loss of stuck-at fault coverage.

This paper presents a new approach on aging sensors for synchronous digital circuits. An adaptive error-prediction flip-flop architecture with built-in aging sensor is proposed, performing on-line monitoring of long-term performance degradation of CMOS digital systems. The main advantage is that the sensor's performance degradation works in favor of the predictive error detection. The sensor is out of the signal path. Performance error prediction is implemented by the detection of late transitions at flip-flop data input, caused by aging (namely, due to NBTI), or to physical defects activated by long lifetime operation. Such errors must not occur in safety-critical systems (automotive, health, space). A sensor insertion algorithm is also proposed, to selectively insert them in key locations in the design. Sensors can be always active or at pre-defined states. Simulation results are presented for a balanced pipeline multiplier in 65 nm CMOS technology, using Berkeley Predictive Technology Models (PTM). It is shown that the impact of aging degradation and/or PVT (Process, power supply Voltage and Temperature) variations on the sensor enhance error prediction.

Complex electronic systems for safety or mission-critical applications (automotive, space) must operate for many years in harsh environments. Reliability issues are worsening with device scaling down, while performance and quality requirements are increasing. One of the key reliability issues is to monitor long-term performance degradation due to aging in such harsh environments. For safe operation, or for preventive maintenance, it is desirable that such monitoring may be performed on chip. On-line built-in aging sensors (activated from time to time) can be an adequate solution for this problem. The purpose of this paper is to present a novel methodology for electronic systems aging monitoring, and to introduce a new architecture for an aging sensor. Aging monitoring is carried out by observing the degrading timing response of the digital system. The proposed solution takes into account power supply voltage and temperature variations and allows several levels of failure prediction. Simulation results are presented, that ascertain the usefulness of the proposed methodology.

In this paper, high-voltage (HV)-tolerant level shifters with combinational functionality are proposed based on differential cascode voltage switch logic (DCVSL). These level shifters are tolerant to supply voltages higher than the process limit for individual CMOS transistors. The proposed HV DCVSL level shifters are particularly useful when it is mandatory to constrain the output using a logic function during out of the normal mode periods (power-up, power-down, reset, etc.). These HV-tolerant logic circuits were used in the power block of a buck converter designed in a standard 3.3-V 0.13-mum CMOS process, powered by an input voltage range from 2.7 to 4.2 V. Simulation and experimental results of the buck are analyzed, and the topology is evaluated.

Performance tests of some aspects of the CMS ECAL were carried out on modules of the "barrel" sub-system in 2002 and 2003. A brief test with high energy electron beams was made in late 2003 to...