Electrolytic conductivity (EC) sensors are widely used in diverse industries, including: pharmaceuticals, food, power, manufacturing, and environmental monitoring. This article presents an overview and analysis of EC sensors used in these industries from the lowest to the highest range of conductivities and in applications, where there are strong requirements for accurate and traceable conductivity measurements of water and electrolyte solutions. Included are reported sensor designs based on two- and four-electrodes with parallel plates, coaxial cylinders, van der Pauw configurations, planar and miniature configurations, and contactless inductive or capacitive coupling. A comprehensive list of exact analytical formulas for computation of cell constants for the configurations is provided. The advantages and disadvantages of using frequency domain or time domain measurement schemes in these sensors are discussed, and the reader is guided to select the suitable method of sensor calibration among the methods available, computing uncertainty budgets, ensuring traceability to the International System of Units (SI) and compliance with standards, such as Pharmacopeias. Finally, trends in the development of EC sensors and the related challenges in relation to calibration and compliance with standards are presented. This article also introduces the reader to the EC cell of a sensor, which can be modeled by solving the Poisson-Nernst-Planck equations or using appropriate equivalent circuit diagrams. It is stepwise described how the models can be extended to include effects such as electrode polarization and steric effects of ions, and it is illustrated by means of an ideal EC cell, where guards eliminate fringe fields, that the simplest equivalent circuit with a single resistor and a single capacitor models electrolytic sensor data very well in the lower range of electrolytic conductivities.
Measurement of pH in aqueous-organic mixtures with different compositions is of high importance in science and technology, but it is, at the same time, challenging both from a conceptual and practical standpoint. A big part of the difficulty comes from the fundamental incomparability of conventional pH values between solvents (spH, solvent-specific scales). The recent introduction of the unified pH (pHabs) concept opens up the possibility of measuring pH, expressed as , in a way that is comparable between solvent, and, thereby, removing the conceptual problem. However, practical issues remain. This work presents the experience of the authors with measuring values in mixtures of methanol, ethanol, and acetonitrile, with water, but without the presence of buffers or other additives. The aim was to assigned values to solvent–water mixtures using differential potentiometry and the ‘pHabs-ladder’ method. Measurements were made of the potential difference between glass electrodes immersed in different solutions, separated by an ionic liquid salt bridge. Data were acquired for a series of solutions of varying solvent content. This work includes experiences related to: a selection of commercial electrodes, purity of starting material, and comparability between laboratories. Ranges of values for selected compositions of solvent–water mixtures are presented.