Ficin extract has been immobilized on different 4% aminated-agarose beads. Using just ion exchange, immobilization yield was poor and expressed activity did not surpass 10% of the offered enzyme, with no significant effects on enzyme stability. The treatment with glutaraldehyde of this ionically exchanged enzyme produced an almost full enzyme inactivation. Using aminated supports activated with glutaraldehyde, immobilization was optimal at pH 7 (at pH 5 immobilization yield was 80%, while at pH 9, the immobilized enzyme became inactivated). At pH 7, full immobilization was accomplished maintaining 40% activity versus a small synthetic substrate and 30% versus casein. Ficin stabilization upon immobilization could be observed but it depended on the inactivation pH and the substrate employed, suggesting the complexity of the mechanism of inactivation of the immobilized enzyme. The maximum enzyme loading on the support was determined to be around 70 mg/g. The loading has no significant effect on the enzyme stability or enzyme activity using the synthetic substrate but it had a significant effect on the activity using casein; the biocatalysts activity greatly decreased using more than 30 mg/g, suggesting that the near presence of other immobilized enzyme molecules may generate some steric hindrances for the casein hydrolysis.

The aim of the study was to investigate the effect of using various by-products (orange and apple pomace, tomato peel, pepper peel, prickly pear peel, and prickly pear seed peel) on the dough rheology and properties of gluten-free bread. The by-products were incorporated into a gluten-free bread formulation based on corn and chickpea flours (2/1 w/w). Different levels of each by-product (0, 2.5, 5, and 7.5% in the basic replacement) were tested. Wheat bread and gluten-free bread without the addition of by-products were used as controls. The results indicated that the by-products increased the maximum dough height, the total CO₂ production, and CO₂ retention coefficient compared to unenriched gluten-free dough. The highest K-value consistency coefficient was observed for the dough enriched with the prickly pear peel. The addition of by-products significantly improved (p < 0.0001) the specific volume of gluten-free bread, with values increasing from 1.48 to 2.50 cm³/g. The hierarchical cluster analysis and the constellation plot showed four groups: the wheat bread group, the second group containing the gluten-free control bread, the group with bread enriched by pomace, and the group with bread enriched with peels, exhibit the same effect on gluten-free bread and the peels exhibit the same effect on gluten-free bread.

Incorporation of xanthan gum and locust bean gum in rice flour supplemented by chickpea flour was used to obtain a good quality of nutritionally enriched biscuit for celiac children. Response surface methodology (RSM) was applied to optimize the levels of xanthan and locust bean gum added to the composite gluten-free flour. Analysis was based on the rheological (hardness and viscoelastic) characteristics of the dough and specific volume, water activity, and hardness of the biscuit. The results revealed that the regression and variance analysis coefficients related to the rheological and physical properties of dough and biscuit under the influence of independent variables were sufficient for an adequate and well-fitted response surface model. Linear terms of variables significantly affect most of the dough and biscuit parameters, where the xanthan gum effect was found to be more pronounced than locust bean gum. Interaction terms showed a significant positive effect on the specific volume of the biscuits and a negative effect on the water activity. However, the interactive effect of gums did not significantly affect the rheological parameters of the dough. Optimized conditions were developed to maximize the specific volume of biscuit and minimize water activity and biscuit hardness, while keeping hardness and viscoelastic properties of the dough in range. Predicted responses were found satisfactory for both rheological and physical characteristics of dough and biscuit.

The purpose of this study was to evaluate the caseinolytic and milk-clotting activities of aqueous crude extracts from leaves and latex of the Pergularia tomentosa, to determine their suitability as a rennet substitute. These extracts were subjected to a series of biochemical tests before being used in the production of cheese. The results showed that the enzymatic latex extract had a higher coagulant activity than the leaf extract. However, under different clotting conditions (pH, temperature, and CaCl₂ concentration), both coagulants behaved similarly in the coagulation of Berridge substrate. The SDS-PAGE and zymographic analysis revealed identical protein bands with a single active zone in both extracts, corresponding to a molecular weight of 26.98 kDa and 26.03 kDa in the extract of leaf and latex, respectively. Both extracts were stable to different effectors but strongly inhibited by iodoacetamide and Hg, suggesting it to be a cysteine protease. Both extracts were able to hydrolyze casein and generate peptides of 14 kDa, with excessive hydrolysis of the other casein fractions. The physicochemical parameters of cheese made from latex and leaf extract evolved similarly to control cheese. According to the sensory evaluation, cheese made with latex had a mildly bitter flavor but showed a high acceptance rate (>80%).

This work aimed to examine the rheological properties and structural features of newly developed gluten-free doughs with maize (M), field bean (FB), maize-filed bean (MFB), and maize-field bean improved with hydrothermally-treated maize (IMFB), and compare them with soft wheat (SW) dough as a...

This study aims at the use of freeze-dried camel rennet extract (FDCR) in the manufacture of fresh cheeses from a mixture of camel and goat milk in comparison with the microbial coagulating agent (FDMC). Physical properties, chemical composition, microstructure, and sensory analysis of the cheeses were performed. The recommended amount of FDCR for coagulation of camel–goat milk mixture was 0.2 g/L. The cheese obtained was mainly characterized by dry matter 34.99 ± 0.57% and protein content 36.26 ± 1.75%/DM. Texture profile analysis revealed that the obtained cheese was mainly characterized by cohesiveness 0.32 ± 0.01 and springiness 14.25 ± 0.63 mm. The microstructure showed that the obtained cheese had more and wider pores. FTIR was used to monitor the differences in the gross composition of the obtained cheese compared to that coagulated with FDMC. The main difference was the presence of amide I in the cheese coagulated with FDCR. For X-ray diffraction, the results noted that the use of FDCR as a natural extract in the coagulation of camel–goat milk mixture did not lead to the appearance of crystalline structure in the cheese. For sensory evaluation, the panelists preferred the cheese coagulated with FDCR with a score of 9/15.