Lead‐free relaxor ferroelectrics are promising materials for energy storage applications. To find new material systems for electrostatic capacitors, many researches have dedicated their work to formulate new ecologically safe compositions. In our study, we have prepared (1− x )Ba(Ti 0.93 Sn 0.07 )O 3 − x BiYO 3 (BTS7‐BY) solid solutions via the solid‐state method. The parent composition, Ba(Ti 0.93 Sn 0.07 )O 3 is a ferroelectric‐relaxor crossover material. It reduces its remanent polarization while still maintaining a high maximum polarization. Moderate substitution with BiYO 3 further lowers the remanent polarization, resulting in slimmer polarization loops and increasing the energy storage efficiency to 90 %. Samples with x ≥ 0.06 show a true relaxor behavior with linear‐like polarization loops with character of weakly‐coupled relaxors. Breakdown strength measurements reveal a reduced breakdown strength with increasing BY content. Further investigations of the electrostriction, the band gap, and the electrical microstructure link the homogeneity and grain size of the microstructure to the resulting breakdown strength. This highlights the importance of a homogenous and small‐grained microstructure for enhancing the energy storage properties. Samples with x = 0.06 exhibit the best energy storage properties with a recoverable energy density of 1.11 J/cm 3 at 189 kV/cm with an energy storage efficiency of 74%.
Herein, hot‐spot generation in bulk barium titanate samples is investigated during controlled current ramping at various rates using in situ dilatometry. The incubation of the flash event is separated from dielectric breakdown at high current densities, which has previously been attributed to cause flash incubation in barium titanate. The lower boundary of the onset temperature of the flash event in barium titanate is investigated through conventional flash experiments at high electric fields. Despite incubating through thermal runaway, the lower boundary does not coincide with the Debye temperature of barium titanate.
Highly porous yttrium oxide is fabricated as ion beam target material in order to produce radioactive ion beams via the Isotope Separation On Line (ISOL) method. Freeze casting allows the formation of an aligned pore structure in these target materials to improve the isotope release. Aqueous suspensions containing a solid loading of 10, 15, and 20 vol% were solidified with a unidirectional freeze-casting setup. The pore size and pore structure of the yttrium oxide freeze-casts are highly affected by the amount of solid loading. The porosity ranges from 72 to 84% and the crosslinking between the aligned channels increases with increasing solid loading. Thermal aging of the final target materials shows that an operation temperature of 1400 °C for 96 h has no significant effect on the microstructure. Thermo-mechanical calculation results, based on a FLUKA simulation, are compared to measured compressive strength and forecast the mechanical integrity of the target materials during operation. Even though they were developed for the particular purpose of the production of short-lived radioactive isotopes, the yttria freeze-cast scaffolds can serve multiple other purposes, such as catalyst support frameworks or high-temperature fume filters.