Magnetic tunnel junctions (MTJ) have become of strategic importance due to the large tunneling magnetoresistance ratio (TMR) that they can achieve at room temperature. The largest TMR values observed until now were recorded in MTJs with MgO barriers and CoFeB electrodes after annealing of the junction above the recrystallization temperature of the amorphous CoFeB layers. We have used x-ray reflectivity combined with polarized neutron reflectivity to characterize the structure and the magnetism of multilayers, where the MgO layers were prepared by different methods and annealed at different temperatures. We have found that the MgO preparation method as well as the annealing temperature play a significant role in the systems. A gradient in thickness together with a variation of the scattering length density along the multilayer stacks induce a process of underoxidation or overoxidation, strictly dependent on the MgO production method.
5 April 2023 in International Journal of Hydrogen Energy
Freeze-casting consists of freezing a liquid suspension (aqueous or other), followed by sublimation of the solidified state to the gas state under reduced pressure, and subsequent sintering of the remaining scaffold to consolidate and densify the struts and walls. The structure is very porous with the pores being a replica of the solvent crystals. The technique is rather versatile and the use of a liquid solvent (water most of the time) as a pore forming agent is a strong asset. Freeze-casting has also been developed as a near net shape forming route yielding dense ceramics. In this work we report on porous composite materials synthesized via the ice templating method. Poly(vinyl alcohol) (PVA) is used as matrix and nano-silica (SiO2), nanoclay (NC) and microfibrillated cellulose (MFC) are used as fillers to improve the mechanical stability of the PVA scaffold. We show our results on the porosity and mechanical stability and consider these porous nanocomposites as potential insulation materials with low thermal conductivity and superior mechanical properties.
Highly porous yttrium oxide is fabricated as ion beam target material in order to produce radioactive ion beams via the Isotope Separation On Line (ISOL) method. Freeze casting allows the formation of an aligned pore structure in these target materials to improve the isotope release. Aqueous suspensions containing a solid loading of 10, 15, and 20 vol% were solidified with a unidirectional freeze-casting setup. The pore size and pore structure of the yttrium oxide freeze-casts are highly affected by the amount of solid loading. The porosity ranges from 72 to 84% and the crosslinking between the aligned channels increases with increasing solid loading. Thermal aging of the final target materials shows that an operation temperature of 1400 °C for 96 h has no significant effect on the microstructure. Thermo-mechanical calculation results, based on a FLUKA simulation, are compared to measured compressive strength and forecast the mechanical integrity of the target materials during operation. Even though they were developed for the particular purpose of the production of short-lived radioactive isotopes, the yttria freeze-cast scaffolds can serve multiple other purposes, such as catalyst support frameworks or high-temperature fume filters.