Surface plasmon resonance biosensors based on grating coupling exhibiting two plasmons are less known because usually thick gratings and thick metal films are used. In this paper we show that when thin dielectric grating is used on top of thin metal film two surface plasmons are generated at the two boundaries of the metal film represented as two dips in the reflectivity or peaks in the absorption. One of the plasmons is sensitive to the analyte refractive index (sensitivity 580nm/RIU) while the other is sensitive to the refractive index of the substrate; hence it can be used as a reference. This self-reference makes the measurement more accurate and less sensitive to temperature fluctuations and optomechanical drifts. Field distribution calculations show that the plasmon excited at the metal-substrate interface is a long range plasmon with large penetration depth.
Dielectric grating-based sensors are usually based on the guided mode resonance (GMR) obtained using a thin planar waveguide layer (PWL) adjacent to a thin subwavelength grating layer. In this work, we present a detailed investigation of thick subwavelength dielectric grating structures that exhibit reflection resonances above a certain thickness without the need for the waveguide layer, showing great potential for applications in biosensing and tunable filtering. Analytic and numerical results are thoroughly discussed, as well as an experimental demonstration of the structure as a chemical sensor in the SWIR (short wave infrared) spectral range (1200–1800 nm). In comparison to the GMR structure with PWL, the thick grating structure has several unique properties: (i) It gives higher sensitivity when the spaces are filled, with the analyte peaking at certain space values due to an increase in the interaction volume between the analyte and the evanescent optical field between the grating lines; (ii) the TM (transverse magnetic) resonance, in certain cases, provides a better figure of merit; (iii) the sensitivity increases as the grating height increases; (iv) the prediction of the resonance locations based on the effective medium approximation does not give satisfactory results when the grating height is larger than a certain value, and the invalidity becomes more severe as the period increases; (v) a sudden increase in the Q-factor of the resonance occurs at a specific height value accompanied by the high local field enhancement (~103) characteristic of a nano-antenna type pattern. Rigorous numerical simulations of the field distribution are presented to explain the different observed phenomena.
25 August 2020 in ACS Applied Materials & Interfaces
It is shown that surface-enhanced Raman spectroscopy (SERS) can identify bacteria based on their genomic DNA composition, acting as a "sample-distinguishing marker". Successful spectral differentiation of bacterial species was accomplished with nanogold aggregates synthesized through single-step plasma reduction of the ionic gold-containing vapored precursor. A high enhancement factor (EF = 107) in truncated coupled plasmonic particulates allowed SERS-probing at nanogram sample quantities. Simulations confirmed the occurrence of the strongest electric field confinement within nanometric gaps between gold dimers/chains from where the molecular fingerprints of bacterial DNA fragments gained photon scattering enhancement. The most prominent Raman modes linked to fundamental base-pair molecular vibrations were deconvoluted and used to proceed with nitrogenous base content estimation. The genomic composition (percentage of guanine-cytosine and adenine-thymine) was successfully validated by third-generation sequencing using nanopore technology, further proving that the SERS technique can be employed to swiftly specify bioentities by the discriminative principal-component statistical approach.
Reflecting gratings with narrow grooves exhibit multiple electromagnetic modes. Using a simple setup, surface plasmon (SP), cavity mode (CM) resonance shift, surface-enhanced fluorescence (SEF), and surface-enhanced Raman scattering signals can be measured, thus forming a multimodal sensing or imaging system. The nature of these modes is first analyzed using dispersion curves as a function of the wavelength, thickness, and period and then confirmed experimentally. For a thin (20 nm) enough grating, the resonant modes are shown to be mainly attributed to SP excitation. Increasing the grating thickness allows the excitation of CMs, and more importantly, coupling between the two resonant modes can take place under certain conditions, leading to a change in the sign of the radius of curvature of the CM branch near the SP wavelength. Field distribution calculations show an agreement with the dispersion curve analysis expressing the nature of the three mode field. Additionally, the SP wavelength was shown to separate between the cavity and diffraction mode branches. The resonant modes can be controlled by tuning the grating parameters and are shown to be spread over a wide spectral range. Experimental verification (sensing in the visible and infrared ranges and SEF experiments) of the observed phenomena is performed on a 154 nm thick silver grating with 1050 nm period fabricated using electron beam lithography. Multimodal systems are important to provide as much as possible information on the measured samples, such as the concentration of analytes and characterization of cells and tissue.
Resonant-based sensors are attractive optical structures due to the easy detection of shifts in the resonance location in response to variations in the analyte refractive index (RI) in comparison to non-resonant-based sensors. In particular, due to the rapid progress of nanostructures fabrication methods, the manufacturing of subwavelength and nano-scale gratings in a large area and at a low cost has become possible. A comparative study is presented involving analysis and experimental work on several subwavelength and nanograting structures, highlighting their nano-scale features’ high potential in biosensing applications, namely: (i) Thin dielectric grating on top of thin metal film (TDGTMF), which can support the excitation of extended surface plasmons (ESPs), guided mode resonance, or leaky mode; (ii) reflecting grating for conventional ESP resonance (ESPR) and cavity modes (CMs) excitation; (iii) thick dielectric resonant subwavelength grating exhibiting guided mode resonance (GMR) without a waveguide layer. Among the unique features, we highlight the following: (a) Self-referenced operation obtained using the TDGTMF geometry; (b) multimodal operation, including ESPR, CMs, and surface-enhanced spectroscopy using reflecting nanograting; (c) phase detection as a more sensitive approach in all cases, except the case of reflecting grating where phase detection is less sensitive than intensity or wavelength detection. Additionally, intensity and phase detection modes were experimentally demonstrated using off-the-shelf grating-based optical compact discs as a low-cost sensors available for use in a large area. Several flexible designs are proposed for sensing in the visible and infrared spectral ranges based on the mentioned geometries. In addition, enhanced penetration depth is also proposed for sensing large entities such as cells and bacteria using the TDGTMF geometry.