The design and fabrication of novel electrochemical sensors with high analytical and operational characteristics are one of the sustainable trends in modern analytical chemistry. Polymeric film formation by the electropolymerization of suitable monomers is one of the methods of sensors fabrication. Among a wide range of the substances able to polymerize, the phenolic ones are of theoretical and practical interest. The attention is focused on the sensors based on the electropolymerized natural phenolic antioxidants and their analytical application. The typical electropolymerization reaction schemes are discussed. Phenol electropolymerization leads to insulating coverage formation. Therefore, a combination of electropolymerized natural phenolic antioxidants and carbon nanomaterials as modifiers is of special interest. Carbon nanomaterials provide conductivity and a high working surface area of the electrode, while the polymeric film properties affect the selectivity and sensitivity of the sensor response for the target analyte or the group of structurally related compounds. The possibility of guided changes in the electrochemical response for the improvement of target compounds’ analytical characteristics has appeared. The analytical capabilities of sensors based on electropolymerized natural phenolic antioxidants and their future development in this field are discussed.
Voltammetric sensors based on CeO2, SnO2, CeO2·Fe2O3 nanoparticles (NPs) and MnO2 nanorods (NRs) were developed for the quantification of various organic substances. Surfactant media were applied as dispersive agents for metal oxide nanomaterials, providing a high stability of the dispersions after sonication and a decrease in the NPs’ size, as well as the preconcentration of the target analytes at the sensor surface due to the hydrophobic interactions between the surfactant and the analyte molecules. Natural phenolics (quercetin, rutin, gallic acid, taxifolin, eugenol, vanillin, and hesperidin), propyl gallate, α-lipoic acid, and synthetic food colorants (tartrazine, brilliant blue FCF, and sudan I) were studied as analytes. The effect of the nature and concentration of the surfactant on the target analyte response was evaluated. Cationic surfactants (cetylpyridinium (CPB) or cetyltriphenylphosphonium bromides (CTPPB)) showed the best effect for the majority of the analytes. Wide linear dynamic ranges and low detection limits were obtained and were improved vs. reported to date. The simultaneous quantification of tartrazine and brilliant blue FCF was achieved with a high selectivity. The practical applicability of the sensors was shown on the real samples and was validated by comparison to independent methods.
1 January 2023 in Uchenye Zapiski Kazanskogo Universiteta. Seriya Estestvennye Nauki
Plants of the Lamiaceae family have been used for thousands of years in cooking, as well as phyto- and aromatherapy. Their essential oils are characterized by high antioxidant and other types of biological activities. In our study, the phytochemical profile and quantification of the essential oil components of thyme, marjoram, and sage were analyzed by gas chromatography with mass-spectrometric detection (GC-MSD). The antioxidant properties of the samples were evaluated using total antioxidant parameters (total antioxidant capacity (TAC), ferric reducing power (FRP), antioxidant activity (AOA) towards 2,2-diphenyl-1-picrylhydrazyl (DPPH•), and total phenolics by Folin–Ciocalteu method). The obtained FRP was 46–321-fold lower than TAC, which is consistent with the contents of phenolics identified in the samples. Terpenes, isopropylmethylphenols, and eugenol turned out to be the major components of all essential oils and determined their TAC and AOA. The Folin–Ciocalteu method was applicable to the thyme essential oil only. Its FRP, which is based on the reaction of phenolic antioxidants with electrogenerated ferricyanide ions, agreed well with the total phenolic contents (329 ± 17 and 334 ± 15 mg of carvacrol per mL, respectively). The thyme essential oil had the highest antioxidant parameters, while sage showed the weakest antioxidant properties. Positive correlations (r = 0.8846–0.9964) of the antioxidant parameters were obtained.
1 January 2019 in Uchenye Zapiski Kazanskogo Universiteta. Seriya Estestvennye Nauki
The electrochemical polymerization of suitable monomers is a powerful way to create voltammetric sensors with improved responses to a target analyte. Nonconductive polymers based on phenolic acids were successfully combined with carbon nanomaterials to obtain sufficient conductivity and high surface area of the electrode. Glassy carbon electrodes (GCE) modified with multi-walled carbon nanotubes (MWCNTs) and electropolymerized ferulic acid (FA) were developed for the sensitive quantification of hesperidin. The optimized conditions of FA electropolymerization in basic medium (15 cycles from −0.2 to 1.0 V at 100 mV s−1 in 250 µmol L−1 monomer solution in 0.1 mol L−1 NaOH) were found using the voltammetric response of hesperidin. The polymer-modified electrode exhibited a high electroactive surface area (1.14 ± 0.05 cm2 vs. 0.75 ± 0.03 and 0.089 ± 0.003 cm2 for MWCNTs/GCE and bare GCE, respectively) and decreased in the charge transfer resistance (21.4 ± 0.9 kΩ vs. 72 ± 3 kΩ for bare GCE). Under optimized conditions, hesperidin linear dynamic ranges of 0.025–1.0 and 1.0–10 µmol L−1 with a detection limit of 7.0 nmol L−1 were achieved, which were the best ones among those reported to date. The developed electrode was tested on orange juice and compared with chromatography.
Sensors with electrochemically formed polymeric films as a sensitive layer are of high interest in electroanalysis. Voltammetric sensors based on the glassy carbon electrodes (GCEs) covered with carbon nanomaterials and electropolymerized phenolic acids (gallic and ellagic) or triphenylmethane dyes (thymolphthalein and aluminon) were developed. Conditions of potentiodynamic electropolymerization were optimized. The electrodes were characterized with scanning electron microscopy, cyclic voltammetry, chronoamperometry, and electrochemical impedance spectroscopy (EIS). In the differential pulse mode, sensors provided a sensitive and selective response to different classes of the antioxidants (capsaicinoids, flavanones, and flavonols). The practical applicability of the sensors was demonstrated on food and plant samples.