Zaid AL-Husban

Dr. Zaid AL-Husban


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 June 2022 in International Journal of Sediment Research
Verified
Journal Article
Closed access
ZAZaid AL-Husban
Zaid AL-Husban
MVManousos Valyrakis
Manousos Valyrakis

9 August 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
ZAZaid AL-Husban
Zaid AL-Husban
Manousos ValyrakisManousos Valyrakis
Manousos Valyrakis
Sediment transport at near threshold to low transport stages (below the continuous transport) can still be affected by flow turbulence and its dynamics can benefit from further comprehensive studies. This study uses an instrumented particle embedded with micro electromechanical sensors (MEMS) to allow tracking the motions and forces acting on it, leading to and during its transport. Instrumented particle transport experiments were carried out at laboratory flume under a range of flow conditions. The probability distributions functions (PDFs) of bed load particle instantaneous velocities, hop distances and associated travel times (measured from start to stop of transport) were obtained for all the performed experiments with varying flow rates and particle density. The modelled distributions are useful and enable a deeper understanding of bed load sediment transport dynamics from a Lagrangian perspective. Furthermore, the results analyzed from the instrumented particle (including the particle’s transport mode) were validated using visual particle tracking methods (top and side cameras). The findings of this study demonstrate that for the range of turbulent flows trialed herein, the instrumented particle can be a useful, accessible, and low-cost tool for obtaining particle transport dynamics, having demonstrated satisfactory potential for field deployment in the near future.

23 March 2020
Verified
Conference Paper
Open access
ZAZaid AL-Husban
Zaid AL-Husban
Manousos ValyrakisManousos Valyrakis
Manousos Valyrakis
Despite the fact sediment transport has been studied for decades, there is still a need to gain a further insight on the nature and driving mechanisms of bed particle motions induced by turbulent flows, for the low transport stages where the particle transport is relatively intermittent. A custom designed and prototyped instrumented particle, embedded with inertial sensors is used herein to study its transport over hydraulically rough bed surfaces. The calibration and error estimation for its sensors is also undertaken before starting the experiments, to ensure optimal operation and estimate any uncertainties.The observations and results of this research are obtained from experiments carried out at the University of Glasgow 12 meters long and 0.9 meters wide, tilting and water recirculating flume. The flume walls comprise of smooth transparent glass that enables observing particle transport from the side (also with underwater video cameras) and the bed surface generally is layered with coarse gravel.The particle is initially located at the upstream end of the test configuration, fully exposed to the uniform and fully developed turbulent channel flow. The top and side cameras are set in their suitable positions to monitor and study the behaviour of particle motion by capturing the dynamical features of sediment motion and to not interfere with flow field that pushes particle downstream. Using the sensor data to calculate the kinetic energy for a range of sets of sediment transport experiments with varying flow rates and particle densities, the probability distribution functions (PDFs) of particle transport features, such as particle’s total energy, are generated which give information about particle interaction with the surface bed during its motion. In addition, the effects of different flow rates, particle densities on particle energy are assessed.

15 May 2023
Verified
Conference Paper
Open access
ZAZaid AL-Husban
Zaid AL-Husban
LRLorenzo Rovelli
Lorenzo Rovelli
ALAndreas Lorke
Andreas Lorke
When it comes to plastic manufacturing worldwide, more than half of what is produced gets dumped into the world's oceans and rivers. The rivers are the primary pathways for plastics to reach the seas. The infiltration behavior of plastic particles into mobile sediment beds (coarse sand) with median diameters (d50) between 0.4 and 0.8 mm was studied using flume experiments with varying plastic particle parameters (such as density and size) under a variety of controlled hydraulic settings.The results are thought to be very useful for improving our understanding of and research into how microplastic particles with different characteristics infiltrate into rivers and streams (in mobile beds) with different bedload rates and stay there. The findings showed that microplastic particles were present in both the stationary and mobile sediment layers of the moving sandy bedforms. The number of particles that infiltrate into the sediment is influenced by particle sizes, densities, and bedform characteristics. In general, it was found that the distributions of microplastic particles of different types and sizes in migrating sandy sediment were heterogeneous, although certain trends could be seen, such as a reduction in infiltration rate and average infiltration depth with increasing bedform celerity. Higher infiltration depths and infiltration percentages are also seen for denser and smaller particles. Additionally, the ratio of infiltrated particles in stationary layers of bedforms to total infiltrated (%) decreases as bedform celerity increases. Using the project's findings, future research and numerical modeling studies on plastic particles' accumulation, distribution, and pathways will be able to inform better decisions about how to clean up future microplastic sediment pollution, as well.

27 March 2022
Verified
Conference Paper
Open access
ZAZaid AL-Husban
Zaid AL-Husban
Manousos ValyrakisManousos Valyrakis
Manousos Valyrakis
HFHamed Farhadi
Hamed Farhadi
In the process of sediment exchange from one region of the water column to another, morphological development occurs, as does the transmission of varying sediment concentrations and flow momentum along the stream. Herein, a one-dimensional hydro-morphodynamic model is proposed for simulating water flow over a rolling bed of non-cohesive materials to understand better how water flows. Flow hydrodynamics, sediment movement, and bed growth are all considered in this simulation. The governing equations were solved using first-order accurate Harten Lax-van Leer solvers, and the fluxes at cell sides were determined using a finite volume technique based on a structured rectangular mesh. Adding geometry and bed topography to the equations in both the x and y axes may be used to convert a onedimensional model to a two-dimensional model, which is a common approach to transforming one-dimensional models into two-dimensional models. Experimental measurements are also utilized to test and assess the integrated model.

28 March 2022
Verified
Conference Paper
Open access
HFHamed Farhadi
Hamed Farhadi
YXYi Xu
Yi Xu
Panagiotis MichalisPanagiotis Michalis
Panagiotis Michalis
ZAZaid AL-Husban
Zaid AL-Husban
Manousos ValyrakisManousos Valyrakis
Manousos Valyrakis
Bed particle motion as bedload transport in riverine flows is a topic of interest in scientific and engineering fields as it is responsible for erosion and sedimentation, which are essential for hydraulic structures design and maintenance [1] but also for river and basin management. The physics of particle motion as the bedload is governed by stochastic processes which interrelated various parameters and conditions (i.e., particle-particle and particle-flow interrelations). Therefore, applying physically-based or hydrodynamic modeling is not always intuitive because of the complex dynamics. In these situations, in which physics is complex, data-driven modeling approaches may yield an efficient alternative approach since it solely considers the relations among the data. Artificial intelligence models (as for data-driven approach) have offered robust predictive performance in various fields of study. In addition, for time-series and sequential forecasting, a beneficial approach is to choose a model that relates previous states to predict future events.This study contributes to developing a Long Short-Time Memory (LSTM) neural network modeling to predict the particle displacements near-threshold conditions. In order to prepare the data needed for the study, experimental tests were conducted in a hydraulic laboratory on a tilting recirculating flume with a 2000 (length) cm × 60 (width) cm dimension. Laser Doppler Velocimetry (LDV) was applied to record the flow velocity time-series upstream of the particle with 350-hertz frequency. Also, a He-Ne laser with a photomultiplier tube was used to track the particle motion [2]. Data were pre-processed with some statistical approaches for outlier detections and normalization purposes [3]. Therefore, different training and validation datasets ratios were considered, and the results were analyzed with some statistical measures (i.e., MAPE and RMSE).The proposed input-output architecture (based on the hydrodynamic forces acting on the bed particle) was a function of the future particle displacement and local instantaneous streamwise flow velocity (about 1 diameter upstream of it). Accordingly, the proposed LSTM model achieved high particle displacement prediction accuracy even for lower percent data conditions for model training. References[1] Michalis, P., Saafi, M. and Judd, M. (2012). Wireless sensor networks for surveillance and monitoring of bridge scour. Proceedings of the XI International Conference Protection and Restoration of the Environment - PRE XI. Thessaloniki, Greece, pp. 1345–1354.[2] Diplas, P., Celik, A.O., Dancey, C.L., Valyrakis, M. (2010). Non-intrusive method for Detecting Particle Movement Characteristics near Threshold Flow Conditions, Journal of Irrigation and Drainage Engineering, 136(11), pp.774-780, DOI:10.1061/(ASCE)IR.1943-4774.0000252.[3] Valyrakis, M., Diplas, P., Dancey, C.L. (2011). Prediction of coarse particle movement with adaptive neuro-fuzzy inference systems, Hydrological Processes, 25(22). pp.3513-3524, DOI:10.1002/hyp.8228.