This review discusses the main aspects of synthesis, structural modification, and practical application of an extremely important class of organic heterocyclic compounds, phthalocyanines and their...

A series of experiments has been carried out in order to construct a master curve generalizing the combined impact of temperature and low viscosity additives on the viscosity of heavy crude oil. The goal was to establish the temperature–diluent concentration relationship to achieve a defined limit of heavy crude oil viscosity suitable for tube transportation. The ultimate viscosity limit was assumed to be 0.2–0.4 Pa·s. Three different industrially acceptable diluents (light oil, light gas oil, and spindle oil) were used for mixing with heavy oil. The viscosities of the mixtures were measured across the whole concentration range at temperatures from –20 to 50 °C. The experimental temperature and concentration dependencies of the mixture viscosity were described by corresponding equations. The data enabled to construct master curves for the determination of temperature–concentration relationships for the suitable viscosity level. The proposed approach can be applied to different heavy crude oil–diluent mixtures.

A series of novel copolyesters based on polyethylene terephthalate (PET) and 4′-hydroxy-biphenyl-4-carboxylic acid (HBCA) was obtained by melt polycondensation of bis(2-hydroxyethyl) terephthalate and 4′-acetoxybiphenyl-4-carboxylic acid (ABCA) as co-monomers with Sb₂O₃ as a catalyst. Using this synthetic procedure, a set of copolymers containing 20–80 mol% of HBCA units was prepared. According to NMR spectroscopy, the copolymers were of random composition. Copolyesters comprising 60–80 mol% of HBCA possessed increased heat resistance and formed nematic melts at 270 °C and higher. The liquid crystal (LC) phase formation was accompanied by transition to non-Newtonian characteristics of the melt flow, as well as an equalization of storage and loss moduli values. According to XRD and polarizing microscopy, the LC glassy phase of the copolyesters coexists with crystalline regions of poly-(4′-hydroxy-4-biphenylcarboxylate), non-melting up to 400 °C and above. The mechanical characteristics of these LC copolyesters showed similar or better values than those of well-known LC polymers. These novel copolyesters can be useful in obtaining heat-resistant materials with an ordered structure and, as a consequence, improved performance.

Several series of new polymers were synthesized in this study: binary copolyesters of vanillic (VA) and 4′-hydroxybiphenyl-4-carboxylic (HBCA) acids, as well as ternary copolyesters additionally containing 4-hydroxybenzoic acid (HBA) and obtained via three different ways (in solution, in melt, and in solid state). The high values of logarithmic intrinsic viscosities and the insolubility of several samples proved their high molecular weights. It was found that the use of vanillic acid leads to the production of copolyesters with a relatively high glass transition temperature (~130 °C). Thermogravimetric analysis revealed that the onset of weight loss temperatures of ternary copolyesters occurred at 330–350 °C, and the temperature of 5% mass loss was in the range of 390–410 °C. Two-stage thermal destruction was observed for all aromatic copolyesters of vanillic acid: decomposition began with VA units at 420–480 °C, and then the decomposition of more heat-resistant units took place above 520 °C. The copolyesters were thermotropic and exhibited a typical nematic type of liquid crystalline order. The mechanical characteristics of the copolyesters were similar to those of semi-aromatic copolyesters, but they were much lower than the typical values for fully aromatic thermotropic polymers. Thus, vanillic acid is a mesogenic monomer suitable for the synthesis of thermotropic fully aromatic and semi-aromatic copolyesters, but the processing temperature must not exceed 280 °C.