The Volterra-series expansion is widely employed to represent the input-output relationship of nonlinear dynamical systems. This representation is based on the Volterra frequency-response functions (VFRFs), which can either be estimated from observed data or through a nonlinear governing equation, when the Volterra series is used to approximate an analytical model. In the latter case, the VFRFs are usually evaluated by the so-called harmonic probing method. This operation is quite straightforward for simple systems but may reach a level of such complexity, especially when dealing with high-order nonlinear systems or calculating high-order VFRFs, that it may loose its attractiveness. An alternative technique for the evaluation of VFRFs is presented here with the goal of simplifying and possibly automating the evaluation process. This scheme is based on first representing the given system by an assemblage of simple operators for which VFRFs are readily available, and subsequently constructing VFRFs of the t...
This article describes the results of extensive full-scale experiments carried out on two lively footbridges recently built in Milan, Italy. The objective of the study was to assess the dynamic characteristics of the bridges and the expected vibration level induced by pedestrians. A preliminary vibration analysis of the bridges revealed their potential sensitivity to human-induced vibrations in the vertical direction. Two sets of experiments were carried out, one before and one after the installation of tuned mass dampers. Furthermore, bridge vibrations during a marathon event were recorded and analyzed. Experimental and analytical results were compared for several loading scenarios.
12 December 2017 in Journal of Engineering for Gas Turbines and Power
The component mode synthesis (CMS) based on the Craig–Bampton (CB) method has two strong limitations that appear when the number of the interface degrees-of-freedom (DOFs) is large. First, the reduced-order model (ROM) obtained is overweighed by many unnecessary DOF. Second, the reduction step may become extremely time consuming. Several interface reduction (IR) techniques addressed successfully the former problem, while the latter remains open. In this paper, we tackle this latter problem through a simple IR technique based on an a-priory choice of the interface modes. An efficient representation of the interface displacement field is achieved adopting a set of orthogonal basis functions determined by the interface geometry. The proposed method is compared with other existing IR methods on a case study regarding a rotor blade of an axial compressor.
Geometric uncertainties in the blade manufacturing process have important consequences in terms of dynamical properties of bladed disks. In this paper, we address the problem of modeling a full bladed disk composed by blades having uncertain geometry. The geometric imperfection of the blades is represented and analyzed according to a procedure previously presented by the authors, based on the principal component analysis (PCA) and the mesh morphing. The dynamical model of the full disk is constructed following the component mode synthesis (CMS) approach. The blade geometry is represented using a probabilistic model constructed from an experimental dataset. The effect of the geometric uncertainties is assessed using a linear uncertainty propagation approach, leading to a procedure that is fast enough to be embedded into a Monte Carlo simulation (MCS) loop.
11 February 2021 in Journal of Engineering for Gas Turbines and Power
The dynamic behavior of bladed disks in resonance crossing has been intensively investigated in the community of turbomachinery, addressing the attention to (1) the transient-type response that appear when the resonance is crossed with a finite sweep rate and (2) the localization of the vibration in the disk due to the blade mistuning. In real conditions, the two mentioned effects coexist and can interact in a complex manner. This paper investigates the problem by means of analytic solutions obtained through asymptotic expansions, as well as numerical simulations. The mechanical system is assumed as simple as possible: a 2DOF linear system defined through the three parameters: damping ratio ξ, frequency mistuning Δ, rotor acceleration Ω̇. The analytic solutions are calculated through the multiple-scale method.