Productivity in the manufacture of aircrafts components, especially engine components, must increase along with more sustainable conditions. Regarding machining, a solution is proposed to increase the cutting speed, but engines are made with very difficult-to-cut alloys. In this work, a comparison between two cutting tool materials, namely (a) cemented carbide and (b) SiAlON ceramics, for milling rough operations in Inconel® 718 in aged condition was carried out. Furthermore, both the influence of coatings in cemented carbide milling tools and the cutting speed in the ceramic tools were analysed. All tools were tested until the end of their useful life. The cost performance ratio was used to compare the productivity of the tested tools. Despite the results showing higher durability of the coated carbide tool, the ceramic tools presented a better behavior in terms of productivity at higher speed. Therefore, ceramic tools should be used for higher productivity demands, while coated carbide tools for low speed-high volume material removal.
28 August 2024 in The International Journal of Advanced Manufacturing Technology
Inconel® 718, known for its excellent mechanical properties in extreme conditions, presents machining challenges due to its low machinability. The chip formation process, influenced by its high ductility and low thermal conductivity, leads to material adhesion and high cutting forces. Ceramic tools have been proposed to mitigate these inconveniences. Textured cutting tools have emerged as a promising solution, aiming to optimise tool-chip contact and, with it, the tribological conditions and the cutting forces. This study investigates the influence of textured grooves on ceramic tools when turning Inconel® 718. Two groove inclinations, 0° and − 25° relative to the cutting edge, were tested. Texturing was performed using a laser station. Experimental results showed improved tool wear characteristics with textured tools, indicating favourable chip extraction and reduced material adhesion. Cutting forces were notably lower with textured tools compared to the reference tool, attributed to reduced notch wear and altered chip flow. Chip morphology analysis revealed differences in chip shape and thermal stability between the reference and textured tools. In conclusion, textured tools, particularly those with − 25° inclined grooves, demonstrated enhanced performance in machining Inconel® 718.