The structural, thermal, electrical and mechanical properties of fully dense B4C ceramics, sintered using Spark Plasma Sintering (SPS), were studied and compared to the properties of B4C ceramics previously published in the literature. New results on B4C’s mechanical responses were obtained by nanoindentation and ring-on-ring biaxial strength testing. The findings contribute to a more complete knowledge of the properties of B4C ceramics, an important material in many industrial applications.
5 April 2017 in Advances in Applied Ceramics: Structural, Functional and Bioceramics
AlMgB14 ceramics were reported as high-hardness materials over a decade ago. While different synthesis routes for processing of AlMgB14 ceramics were reported in the past, however the synthesis routes are still not optimised and present a significant challenge to the manufacturers. In this work six different synthesis routes were explored for the synthesis of AlMgB14 powder. The synthesised compositions were characterised by XRD, where weight fractions of each phase were calculated by Rietveld refinement. The bulk ceramics were sintered using powder with the highest yield (93.2%) of AlMgB14 phase by spark plasma sintering at 1315°C and 50 MPa. Both phase composition and microstructure of the sintered AlMgB14 were characterised by XRD and SEM/EDS, which revealed the existence of AlMgB14, MgAl2O4 and a small amount of unreacted Al. Hardness and indentation fracture resistance of AlMgB14 ceramics were measured to be 26.7 ± 2.2 GPa and 5.59 ± 0.42 MPa m1/2, respectively by Vickers indentation technique.
The influence of diet on the development of osteoporosis is significant and not fully understood. This study investigated the effect of diets of varying lipid profiles and ω-3, ω-6 and ω-9 composition on the structural and mechanical properties of bone. The hypothesis studied was that a diet high in saturated fat would induce osteoporosis and produce an overall increased detrimental bony response when compared with a diet high in unsaturated ω-6, or ω-9. Male C57BL/6J mice were fed either a control diet, 50:50 mix (saturated:unsaturated) high in ω-9 (HFD50:50), a diet high in saturated fat (HSF) or a polyunsaturated fat diet high in ω-6 (PUFA) over an 8-week duration. Tibiae were retrieved and evaluated using DMA, 3-point-bending, histomorphometry, and microCT. Mice fed a HSF diet displayed key features characteristic of osteoporosis. The loss tangent was significantly increased in the HFD50:50 diet group compared with control (p = 0.016) and PUFA-fed animals (p = 0.049). HFD50:50-fed mice presented with an increased viscous component, longer tibiae, increased loss modulus (p = 0.009), and ultimate stress, smaller microcracks (p < 0.001), and increased trabecular width (p = 0.002) compared with control animals. A diet high in ω-9 resulted in an overall superior bone response and further analysis of its role in bone health is warranted.
R-curve and controlled stable crack growth behaviour of ZrB2–17vol.-%SiC and ZrB2–45vol.-%SiC ceramic composites was studied on V-notched samples using four-point bending at room temperature. The rising K1R behaviour was determined as a function of the crack extension Δa with a crack bridging mechanism being dominant in such behaviour. Significant differences in crack growth rates were found within the same composition of ceramics simply as the crack length varied during crack growth processes. These differences are indicative of the significant influence of microstructural parameters of the ceramics on crack propagation. The peculiarities of stress intensity factor K1 and the crack growth-specific behaviour in ZrB2–SiC particulate ceramic composites are discussed.