This work is devoted to the evaluation of the efficiency of a new low-temperature plasma jet driven in ambient air by a dc-corona discharge to inactivate adherent cells and biofilms of Gram-positive bacteria. The selected microorganisms were lactic acid bacteria, a Weissella confusa strain which has the particularity to excrete a polysaccharide polymer (dextran) when sucrose is present. Both adherent cells and biofilms were treated with the low-temperature plasma jet for different exposure times. The antimicrobial efficiency of the plasma was tested against adherent cells and 48 h-old biofilms grown with or without sucrose. Bacterial survival was estimated using both colony-forming unit counts and fluorescence-based assays for bacterial cell viability. The experiments show the ability of the low-temperature plasma jet at atmospheric pressure to inactivate the bacteria. An increased resistance of bacteria embedded within biofilms is clearly observed. The resistance is also significantly higher with biofilm in the presence of sucrose, which indicates that dextran could play a protective role.
In this paper we report the experimental investigation of a pure xenon monofilamentary dielectric barrier discharge (DBD), using a high voltage power supply. Stable microdischarges were achieved and studied in the pressure range of , at frequencies between 10 and . Successive exposure time snapshots of the discharge clearly show how it built up. Its diameter was about . The discharge voltage and current were determined from the measurement of the supply voltage and current. Compared to those in argon, the current pulses were shorter (less than , above ) and had much higher peak values. Ignition voltages were also higher in the heavier gas. Electrical energy and vacuum ultraviolet radiation energy of the second continuum of xenon were both independent of frequency. They both varied almost linearly with pressure. The measured DBD vuv efficiency of a single xenon microdischarge reported here was between 55% and 60%, and the maximum value was reached for . These values were twice those reported for multifilamentary discharges working with a sinusoidal supply. They were similar to those obtained for multifilamentary dielectric barrier discharges excited with short voltage pulses.
The present paper is devoted to the 2D simulation of an Atmospheric Corona Discharge Reactor (ACDR) involving 10 pins powered by a DC high voltage and positioned 7 mm above a grounded metallic plane. The corona reactor is periodically crossed by thin mono filamentary streamers with a natural repetition frequency of some tens of kHz. The simulation involves the electro-dynamic, chemical kinetic, and neutral gas hydrodynamic phenomena that influence the kinetics of the chemical species transformation. Each discharge stage (including the primary and the secondary streamers development and the resulting thermal shock) lasts about one hundred nanoseconds while the post-discharge stages occurring between two successive discharge phases last one hundred microseconds. The ACDR is crossed by a lateral air flow including 400 ppm of NO. During the considered time scale of 10 ms, one hundred discharge/post-discharge cycles are simulated. The simulation involves the radical formation and thermal exchange between the discharges and the background gas. The results show how the successive discharges activate the flow gas and how the induced turbulence phenomena affect the redistribution of the thermal energy and the chemical kinetics inside the ACDR.
13 April 2011 in Journal of Physics D: Applied Physics
Mono-filamentary dielectric barrier discharge (MF-DBD), occurring within 1 mm gap of atmospheric pressure pure nitrogen and operating with a sinusoidal electric supply at about 8 kHz, is studied in this paper. A thorough electrical analysis allows experimental determination of the ignition and extinction voltages, respectively (15 750 ± 50) V and (2097 ± 7) V, the injected energy (158 ± 2) J and charge (17.22 ± 0.22) nC in a single filament. The mean axial reduced electric field is equal to (644 ± 2) Td at ignition. An empirical technique is proposed to evaluate these discharge parameters by avoiding bulky calculations. Optical emission spectroscopic measurements of the vacuum ultraviolet (VUV), ultraviolet (UV), visible and near infrared (IR) emissions are presented and discussed. Two atomic nitrogen lines attributed to the decay of the N[2s2p23s2P] triplet towards N[2s22p32D°] level are observed at 150 and 175 nm, together with the Lyman–Birge–Hopfield systemin the VUV range. The second positive system (N2[C3Πu] →N2[B3Πg]) dominates the UV and visible-blue spectra. The (0–0) transition of the first negative systempeaking at 391.4 nm, the first positive systemand the Herman IR transitionsare also present. Both our VUV and near IR spectra are consistent with recently reported results in hollow cathode and cylindrical DBDs. The electrical and spectroscopic experimental results reported here are useful for ongoing and forthcoming modelling of filamentary nitrogen dielectric barrier discharges.
30 April 2007 in Journal of Physics B: Atomic, Molecular and Optical Physics