Electrified vehicles have undergone great evolution during the last decade because of the increasing attention paid on environmental sustainability, greenhouse gas emissions and air pollution. Emission regulations are becoming increasingly tight, and governments have been allocating multiple funds to facilitate the spreading of the so-called green mobility. In this context, steering towards electrified solutions not only for passenger vehicles, but also for compact off-highway vehicles extensively employed, for instance, on construction sites located in urban areas, warehouses, and greenhouses, is essential even if seldom considered. Moreover, the electrification of compact off-highway machinery may allow manufacturers to increase their expertise in and lower the costs of these alternative solutions, while gathering useful data to be applied in bigger and more remunerative off-highway vehicles. In fact, while electric automobiles are as of now real alternatives for buyers, off-highway vehicles, regardless of the application, are mostly in the research and experimental phase, with few of them already on the market. This delay, in comparison with the passenger automotive industry, is caused by different factors, mostly related to the different tasks of off-highway vehicles in terms of duty cycles, productivity performance parameters and user acceptability. The aim of this paper is to give an overview of the many aspects of the electrification of compact off-highway vehicles, to highlight the key differences between on-highway and off-highway vehicles and to summarize in a single source of information the multiple solutions investigated by researchers and manufacturers.
The electrification of utility vehicles represents a promising solution to reduce the emissions in the urban context. Differently from traditional vehicles, they operate intermittently and generally follow routine driving cycles. In this paper, we model a 15-kW electric utility vehicle, adopting a backward-looking approach, widely used in literature to estimate the range of electric cars. The model requires a limited number of data, either supplied by the vehicle manufacturer or found in literature, as in case of the induction motor/generator efficiency and of the battery Peukert coefficient. The model can be used to assess the possibility of the vehicle to complete an assigned mission, as well as to optimize the vehicle’s design and architecture. The model is validated on GPS data obtained through an experimental campaign where the electric utility vehicle was driven to depletion considering different routes, including the effect of slopes. A satisfactory correspondence with the experimental data was observed with maximum difference in the simulated average energy consumption lower than about 8%. Results of the simulations show that the range of the electric utility vehicle is about 110 km on urban flat cycle while it significantly reduces when slopes are included in portions of the routes.
The push for environmental sustainability has accelerated the acceptance of electric vehicles, as well as the exploration of electrified Non-Road Mobile Machinery. This study emphasizes the challenges of electrifying off-highway machinery, which include the many machinery layouts and the presence of Small- and Medium-sized Enterprises in the market. Recognizing the barriers faced by these companies, this paper shows how modeling and simulation can be effective tools for system integration and control optimization, even when lacking extensive expertise in the topic. However, it emphasizes the need for user-friendly modeling tools and methods adaptable to the operational needs of Small- and Medium-sized Enterprises. This study presents a case study of a retrofitted battery-electric hydraulic material handler. The machinery is simulated using Simscape, and the accuracy of the model is confirmed through experimental validation. By simulating a rational duty cycle, this study proposes two solutions for performance enhancement while maintaining the integrity of the hydraulic system. These solutions offer a balanced compromise between energy consumption and productivity and a novel control algorithm to minimize energy consumption. Most importantly, the two proposed solutions can be easily switched by the operator, which can decide to favor productivity over energy saving based on driving needs.