Electrified vehicles have undergone great evolution during the last decade because of the increasing attention paid on environmental sustainability, greenhouse gas emissions and air pollution. Emission regulations are becoming increasingly tight, and governments have been allocating multiple funds to facilitate the spreading of the so-called green mobility. In this context, steering towards electrified solutions not only for passenger vehicles, but also for compact off-highway vehicles extensively employed, for instance, on construction sites located in urban areas, warehouses, and greenhouses, is essential even if seldom considered. Moreover, the electrification of compact off-highway machinery may allow manufacturers to increase their expertise in and lower the costs of these alternative solutions, while gathering useful data to be applied in bigger and more remunerative off-highway vehicles. In fact, while electric automobiles are as of now real alternatives for buyers, off-highway vehicles, regardless of the application, are mostly in the research and experimental phase, with few of them already on the market. This delay, in comparison with the passenger automotive industry, is caused by different factors, mostly related to the different tasks of off-highway vehicles in terms of duty cycles, productivity performance parameters and user acceptability. The aim of this paper is to give an overview of the many aspects of the electrification of compact off-highway vehicles, to highlight the key differences between on-highway and off-highway vehicles and to summarize in a single source of information the multiple solutions investigated by researchers and manufacturers.
This work analyses the effect of friction in suspension components on a race car vertical dynamics. It is a matter of fact that race cars aim at maximising their performance, focusing the attention mostly on aerodynamics and suspension tuning: suspension vertical and rolling stiffness and damping are parameters to be taken into account for an optimal setup. Furthermore, friction in suspension components must not be ignored. After a test session carried out with a F4 on a Four Poster rig, friction was detected on the front suspension. The real data gathered allow the validation of an analytical model with friction, confirming that its influence is relevant for low frequency values closed to the car pitch natural frequency. Finally, some setup proposals are presented to describe what should be done on actual race cars in order to correct vehicle behaviour when friction occurs.