Improvements in miniaturization and boosting the thermal performance of energy conservation systems call for innovative techniques to enhance heat transfer. Heat transfer enhancement methods have attracted a great deal of attention in the industrial sector due to their ability to provide energy savings, encourage the proper use of energy sources, and increase the economic efficiency of thermal systems. These methods are categorized into active, passive, and compound techniques. This article reviews recent passive heat transfer enhancement techniques, since they are reliable, cost-effective, and they do not require any extra power to promote the energy conversion systems’ thermal efficiency when compared to the active methods. In the passive approaches, various components are applied to the heat transfer/working fluid flow path to improve the heat transfer rate. The passive heat transfer enhancement methods studied in this article include inserts (twisted tapes, conical strips, baffles, winglets), extended surfaces (fins), porous materials, coil/helical/spiral tubes, rough surfaces (corrugated/ribbed surfaces), and nanofluids (mono and hybrid nanofluids).

In the present work, a parabolic trough solar (PTC) collector with inner helical axial fins as swirl generator or turbulator is considered and analyzed numerically. The three-dimensional numerical simulations have been done by finite volume method (FVM) using a commercial CFD code, ANSYS FLUENT 18.2. The spatial discretization of mass, momentum, energy equations, and turbulence kinetic energy has been obtained by a second-order upwind scheme. To compute gradients, Green-Gauss cell-based method has been employed. This work consists of two sections where, first, four various geometries are appraised, and in the following, the selected schematic of the collector from the previous part is selected, and four various pitches of inner helical fins including 250, 500, 750 and 1000 mm are studied. All the numerical results are obtained by utilizing the FVM. Results show that the thermal performance improvement by 23.1% could be achieved by using one of the proposed innovative parabolic trough solar collectors compare to the simple one. Additionally, the minimum and maximum thermal performance improvement (compare to the case without fins) belong to the case with P = 250 mm by 14.1% and, to the case with P = 1000 mm by 21.53%, respectively.

This paper reviews the impacts of employing inserts, nanofluids, and their combinations on the thermal performance of flat plate solar collectors. The present work outlines the new studies on this specific kind of solar collector. In particular, the influential factors upon operation of flat plate solar collectors with nanofluids are investigated. These include the type of nanoparticle, kind of base fluid, volume fraction of nanoparticles, and thermal efficiency. According to the reports, most of the employed nanofluids in the flat plate solar collectors include Al₂O₃, CuO, and TiO₂. Moreover, 62.34%, 16.88%, and 11.26% of the utilized nanofluids have volume fractions between 0 and 0.5%, 0.5 and 1%, and 1 and 2%, respectively. The twisted tape is the most widely employed of various inserts, with a share of about one-third. Furthermore, the highest achieved flat plate solar collectors’ thermal efficiency with turbulator is about 86.5%. The review is closed with a discussion about the recent analyses on the simultaneous use of nanofluids and various inserts in flat plate solar collectors. According to the review of works containing nanofluid and turbulator, it has been determined that the maximum efficiency of about 84.85% can be obtained from a flat plate solar collector. It has also been observed that very few works have been done on the combination of two methods of employing nanofluid and turbulator in the flat plate solar collector, and more detailed work can still be done, using more diverse nanofluids (both single and hybrid types) and turbulators with more efficient geometries.