In recent decades, novel and promising graphene-based materials (i.e., carbon nanotubes, nanoporous graphene and graphene oxide) suitable to be used in preparation of high-capacity membranes for water desalination and water and wastewater treatment have been developed. After detail recognition of properties of nanoporous graphene and graphene oxide-based materials, the general conclusion on preparation of membranes made of only graphene or only graphene oxide as well as other composite materials involving these nanomaterials has been given. Novel composite membranes containing nanoporous graphene and, first of all, graphene oxide can be divided into two groups: (i) freestanding membranes made only of graphene or only of graphene oxide, and (ii) polymeric/ceramic membranes modified with the use of graphene-based nanomaterials. The modification of polymeric membranes can be achieved either by introduction of a nanomaterial onto a membrane surface or its addition to a membrane casting solution followed by membrane formation from a polymer and a nanomaterial mixture. Membranes based on nanomaterials enable to obtain significantly higher water/permeate fluxes than currently used thin film composite polyamide membranes. The future prospect of membranes based on nanoporous graphene and graphene oxide in regard to the final separation efficiency and commercial scaling up has been discussed.

The article presents results of the research on the use of chars produced during pyrolysis of residual biomass as a substitutional fuel in the iron ore sintering process. Such an approach allows to implement circular economy and industrial symbiosis to the iron and steel branches. The effect of the substitution of conventional coke breeze fuel used in sintering on final sinter quality and emission was examined. With regard to productivity, fuel consumption, and properties of the sinter it was shown that the share of tested biochars in fuel may be kept at 10, and up to 30 wt.%, depending on the biochar type. It was observed that with the use of the biochars, the content of iron oxide in the sinter decreased, which was advantageous. Moreover, the sinter obtained in the presence of biochars was characterized with better strength and abrasion than the sinter obtained with coke breeze-based fuel, improving the final product quality. The presence of biochar influenced the raw exhaust gas composition and resulted in a slight increase of organic and inorganic carbon compounds content, while the amount of sulfur oxides was noticeably decreased. It was concluded that the biochars may be applied in the sintering process at established share in the fuel stream.

Coke oven liquor is one of the most contaminated liquid streams generated by the coal processing industry, thus its proper treatment and utilization is crucial for sustainable and environmentally neutral plant operation. The conventional wastewater treatment process comprises of chemical and biological processes. Within the current research the detailed role of chemical treatment is described. Commercially available iron-based coagulants (PIX100, PIX100COP, PIX113, PIX116) were tested to understand their removal efficiency and impact on the stream parameters. The influence of iron dose in the range of 300-500 mgFe/L on the process performance was also examined. It was found that the main role of chemical treatment was to bind toxicants harmful to activated sludge microorganisms, i.e. free and complex cyanides and sulphides. Among the tested iron-based conventional coagulants ferrous salts were more efficient than ferric salts. It was also observed that efficiency of the process strongly depended on wastewater properties (especially in regard to pH, which should be in the range of 9-10) and the coagulant selection needed to be done individually for a given wastewater type. The removal rates of particular contaminants were diversified and for free cyanides, complex cyanides and sulphides they were in the range of 23-91%, -156-77% and -357-98%, respectively. The expected, simultaneous removal of chemical oxygen demand (COD) during the treatment was not observed and even the parameter value increased after the process due to probable formation of compounds less vulnerable to oxidation.

Gasification of solid fuels is an alternative process for energy production using conventional and renewable fuels. Apart from desired compounds, i.e. carbon oxide, hydrogen and methane, the produced gas contains complex organic (tars) and inorganic (carbonizate, ammonia) contaminants. Those...