We report on lateral pin germanium photodetectors selectively grown at the end of silicon waveguides. A very high optical bandwidth, estimated up to 120GHz, was evidenced in 10 µm long Ge photodetectors using three kinds of experimental set-ups. In addition, a responsivity of 0.8 A/W at 1550 nm was measured. An open eye diagrams at 40Gb/s were demonstrated under zero-bias at a wavelength of 1.55 µm.
9 October 2009 in IEEE Transactions on Circuits and Systems II: Express Briefs
A comparator in a low-power 65-nm complementary metal-oxide-semiconductor process (only standard transistors with threshold voltage Vt ap 0.4 V were used) is presented, where the circuit of a conventional latch-type comparator consisting of two cross-coupled inverters is modified for fast operation, even with 0.6 GHz at a low supply voltage of 0.65 V. The advantages of a high-impedance input, rail-to-rail output swing, robustness against the influence of mismatch, and no static power consumption are kept. To achieve a bit error rate of 10-9 at 1.2-V supply, an amplitude at the input of 16.5 mV at 4 GHz has to be applied. If the supply voltage is lowered, 12.1 mV at 0.6 GHz/0.65 V is necessary. The power consumption of the comparator is 2.88 mW at 5 GHz (1.2 V) and 128 muW at 0.6 GHz (0.65 V). Simulations show an offset standard deviation of about 6.1 mV at 0.65-V supply. With an on-chip measurement circuit, the delay time of the comparator of, e.g., 104 ps for 15-mV input amplitude at 1.2-V supply, is obtained.
An optical wireless communication system for an operation with wavelengths detectable by silicon optoelectronic integrated circuits is described. We use direct modulated vertical cavity surface emitting lasers as a transmitter. The field of view of the laser beam is adjusted with an adaptive optical system and aligned with a micro-electro-mechanical system based mirror for beam steering. To receive the modulated laser beam, we develop a receiver chip in 0.35 μm BiCMOS technology. The experimental system shows a 3 Gb/s wireless transmission over a distance of 7 m with a bit-error rate <;10 -9 without cost intensive optical components and complex adjustment procedure.
This paper aims to present the design and the achieved results on a CMOS electronic and photonic integrated device for low cost, low power, transparent, mass-manufacturable optical switching. An unprecedented number of integrated photonic components (more than 1000), each individually electronically controlled, allows for the realization of a transponder aggregator device which interconnects up to eight transponders to a four direction colorless-directionless-contentionless ROADM. Each direction supports 12 200-GHz spaced wavelengths, which can be independently added or dropped from the network. An electronic ASIC, 3-D integrated on top of the photonic chip, controls the switch fabrics to allow a complete and microsecond fast reconfigurability.