In this paper, a nondeterministic random number generator based on detection of the single photons emitted by an Si-CMOS-LED light source integrated for the first time on the detector chip is presented and experimentally demonstrated. We use a ring-shaped single-photon avalanche diode (SPAD) around the Si-CMOS-LED fabricated in 0.35-μm HV-CMOS technology to generate random events. The time intervals between single-photon events are independent quantum random variables. A field-programmable gate array (FPGA) digitizes the time variables to the stream of random bits. Bias in the raw data due to the nonuniform distribution of the time intervals is removed by postprocessing in a special configuration of xor gates to improve the randomness of the generated random bits. The quantum random numbers in 1-Gb streams with bit generation rate of 1 Mb/s were directly delivered to a personal computer (PC) and passed all statistical tests from ENT, STS, and DIEHARD, as well as for more accuracy correlation and bias tests applied on these streams.
29 March 2016 in IEEE Journal of Selected Topics in Quantum Electronics
This paper aims to present the design and the achieved results on a CMOS electronic and photonic integrated device for low cost, low power, transparent, mass-manufacturable optical switching. An unprecedented number of integrated photonic components (more than 1000), each individually electronically controlled, allows for the realization of a transponder aggregator device which interconnects up to eight transponders to a four direction colorless-directionless-contentionless ROADM. Each direction supports 12 200-GHz spaced wavelengths, which can be independently added or dropped from the network. An electronic ASIC, 3-D integrated on top of the photonic chip, controls the switch fabrics to allow a complete and microsecond fast reconfigurability.
24 October 2017 in IEEE Journal of Selected Topics in Quantum Electronics
The first fully integrated receiver based on single-photon avalanche diodes (SPADs) for data rates of up to 200 Mb/s is reported . An array of four SPADs in combination with quenching circuits and a short dead time of 3.5 ns is fabricated in a 0.35 μm CMOS process. The responses of the SPADs are combined using an integrated digital latch-type processing circuit to create a single output data stream. In addition, the output of each quenching circuit is recorded and the bit error rates are extracted by postprocessing in MATLAB. Using a 635-nm single-mode laser source, the bit error rate at different optical power is measured at 50, 100, 150, and 200 Mb/s. The integrated digital circuit achieved the best sensitivity at –46.3 dBm (BER = 2·10 –3 ) for 100 Mb/s. Using the MATLAB postprocessing, a sensitivity of –43.8 dBm at 200 Mb/s (BER = 6.5·10 –3 ) is reached.
Experimental results of a single-photon avalanche diode (SPAD) based optical fiber receiver integrated in 0.35 µm PIN-photodiode CMOS technology are presented. To cope with the parasitic effects of SPADs an array of four receivers is implemented. The SPADs consist of a multiplication zone and a separate thick absorption zone to achieve a high photon detection probability (PDP). In addition cascoded quenchers allow to use a quenching voltage of twice the usual supply voltage, i.e. 6.6 V instead of 3.3 V, in order to increase the PDP further. Measurements result in sensitivities of −55.7 dBm at a data rate of 50 Mbit/s and −51.6 dBm at 100 Mbit/s for a wavelength of 635 nm and a bit-error ratio of 2 × 10−3, which is sufficient to perform error correction. These sensitivities are better than those of linear-mode APD receivers integrated in the same CMOS technology. These results are a major advance towards direct detection optical receivers working close to the quantum limit.
17 April 2018 in IEEE Solid-State Circuits Letters
In this letter, we present a fully integrated single-photon avalanche diode (SPAD) using a fast cascoded quenching circuit (QC) fabricated in a 0.35-μm CMOS process. The QC features a fast active quenching time of only 0.48 ns and an adjustable total dead time (9.5-17 ns) to further reduce afterpulsing effects. To prove the quenching performance, the circuit was integrated together with a large-area SPAD having an active diameter of 80 μm. Experimental verification of reduction of afterpulsing with early quenching is shown. Thus, a minimal afterpulsing probability of 0.9% was measured at 6.6 V excess bias and a photon detection probability of 22% at a wavelength of 850 nm was achieved.