Carbon Fibre-Reinforced Polymers (CFRPs) in aerospace applications are expected to operate in moist environments where carbon fibres have high resistance to water absorption; however, polymers do not. To develop a truly optimised structure, it is important to understand this degradation process. This study aims to expand the understanding of the role of water absorption on fibrous/polymeric structures, particularly in a matrix-dominant property, namely interlaminar strength. This work used Acoustic Emission (AE), which could be integrated into any Structural Health Monitoring System for aerospace applications, optical strain measurements, and microscopy to provide an assessment of the gradual change in failure mechanisms due to the degradation of a polymer’s structure with increasing water absorption. CFRP specimens were immersed in purified water and kept at a constant temperature of 90 °C for 3, 9, 24 and 43 days. The resulting interlaminar strength was investigated through short-beam strength (SBS) testing. The SBS values decreased as immersion times were increased; the decrease was significant at longer immersion times (up to 24.47%). Failures evolved with increased immersion times, leading to a greater number of delaminations and more intralaminar cracking. Failure modes, such as crushing and multiple delaminations, were observed at longer immersion times, particularly after 24 and 43 days, where a pure interlaminar shear failure did not occur. The observed transition in failure mechanism showed that failure of aged specimens was triggered by a crushing of the upper surface plies leading to progressive delamination at multiple ply interfaces in the upper half of the specimen. The crushing occurred at a load below that required to initiate a pure shear failure and hence represents an under prediction of the true SBS of the sample. This is a common test used to assess environmental degradation of composites and these results show that conservative knockdown factors may be used in design. AE was able to distinguish different material behaviours prior to final fracture for unaged and aged specimens suggesting that it can be integrated into an aerospace asset management system. AE results were validated using optical measurements and microscopy.
The use of Acoustic Emission (AE) to detect impacts is of interest within industries where vital components are prone to impact damage, in particular where Carbon Fibre Reinforced Polymers (CFRP) are used, as damage can often go un-noticed within them. For AE monitoring of impacts piezoelectric sensors are used to detect the ultrasonic wave produced by an impact. Classification is also possible of these waves enabling a distinction between damaging and non-damaging impacts. These sensors do however have resonance, so do not give an accurate picture of how the waves propagate, better knowledge would enable better selection of sensors. Laser Doppler Vibrometry is a non-contact and non-resonant method of analysing the surface displacement on a structure. In this study, a vibrometer was used to monitor CFRP plates during impact to assess its applicability for distinguishing between damaging and non-damaging impacts, compared with a surface mounted AE sensor. The vibrometer was able to detect both low frequency flexural modes due to the impact process and the higher frequency extensional modes, initiated by damage. When compared to the AE sensor the vibrometer was comparable in its results, and unlike the sensor, not susceptible to resonance or decoupling. For the tested material the vibrometer identified frequencies greater than 20 kHz to be associated with damaging impacts.
1 January 2021 in IOP Conference Series: Materials Science and Engineering
This study focuses on understanding the effect of graphene, when introduced in epoxy systems, on the overall moisture absorption capacity and behaviour of epoxy resin composites subjected to hydrothermal conditions. Pristine epoxy resin and epoxy resin incorporating functionalised and unfunctionalised graphene reinforcement were manufactured and exposed to 90°C purified water for 30 days. The flexural and tensile properties were observed for both unaged and aged specimens. A lower moisture absorption capacity was observed for graphene enhanced specimens as opposed to pristine epoxy resin, which suggests the potential of graphene as a barrier to moisture ingress. Despite the lower mass gain observed, the performance of the nano-filled resins exhibits a larger reduction in properties following water absorption.