The viability for dry coupling of piezoelectric ultrasonic transducer components was investigated, using a thin foil of annealed silver as a filler material/coupling agent at each component interface. Criteria used for room temperature evaluation were centered on signal-to-noise ratio (SNR) and echo bandwidth, for a Li-Nb based transducer operating in pulse-echo mode. A normal clamping stress of only 25 MPa, applied repeatedly over three loading cycles on a precisely-aligned transducer stack, was sufficient to yield backwall echoes with a SNR greater than 25 dB, and a 3 dB bandwidth of approximately 65%. This compares to a SNR of 32 dB and a 3 dB bandwidth of 65%, achievable when all transducer interfaces were coupled with ultrasonic gel. The respective roles of a soft filler material, alignment of transducer components, cyclic clamping, component roughness, and component flatness were evaluated in achieving this high efficiency dry coupling, with transducer clamping forces far lower than previously reported. Preliminary high temperature tests indicate that this coupling method is suitable for high temperature and achieves signal quality comparable to that at room temperature with ultrasonic gel.
The interphase in an epoxy-aluminum system has been revealed and characterized using scanning electron microscopy, ion etching, energy-dispersive x-ray analysis, and nano-indentation. The interphase was of irregular thickness, nominally between 2 and 6 μ, and corresponds to a region of greater resistance to ion etching and a marked absence of the silica particles used in the epoxy adhesive. Nano-indentation tests, traversing various sections of the interphase from the aluminum to the bulk resin, showed that the interphase region had, on average, an effective elastic modulus (E/(1-v2)) that was 13% greater than that of the bulk resin, far from the aluminum. The interphase was also approximately 4% harder than the bulk adhesive.
One of the most common methods for performing non-destructive testing in steel tank floors is DC magnetic flux leakage (MFL). The magnetic dipole method is the most widely used mathematical technique to predict the MFL from defects in such structures. However, due to the complexity of an exact analytical description of an MFL system, researchers often make coarse approximations for the profile of the magnetic surface charge density σₘ, orientation of the magnetic field H, and variation of relative permeability μ r. In this paper, the validity of these approximations is evaluated for 2-D rectangular defects in a steel plate, by comparing model predications with finite element results. The primary sources of deviation between the approximate solutions and true MFL profiles were found to be caused by assumptions that 1) σₘ on the specimen surface adjacent to a flaw is zero. This assumption is equivalent to treating the orientation of H to be parallel to the specimen surface, even at locations in close proximity to a flaw and 2) local variation in permeability around the defect can be ignored. This approximation was found to cause an underestimation of σₘ and, consequently, the predicted MFL. In contrast, approximating σₘ to be zero at the bottom of a flaw, and approximating uniform distribution for σ ₘ on the vertical defect sides of a slot defect was found to generate only minor errors in an estimate of flux leakage.
In this special issue of Sensors, seven peer-reviewed manuscripts appear on the topic of ultrasonic transducer design and operation in harsh environments: elevated temperature, high gamma and neutron fields, or the presence of chemically aggressive species. Motivations for these research and development projects are strongly focused on nuclear power plant inspections (particularly liquid-sodium cooled reactors), and nondestructive testing of high-temperature piping installations. It is anticipated that we may eventually see extensive use of permanently mounted robust transducers for in-service monitoring of petrochemical plants and power generations stations; quality control in manufacturing plants; and primary and secondary process monitoring in the fabrication of engineering materials.