Luc Fillaudeau

Dr. Luc Fillaudeau

orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 December 2014 in Biotechnology for Biofuels
Verified
Journal Article
Open access
PDF file
JCJulien Cescut
Julien Cescut
LFLuc Fillaudeau
Luc Fillaudeau
CMCarole Molina-Jouve
Carole Molina-Jouve
JUJean-Louis Uribelarrea
Jean-Louis Uribelarrea
Oleaginous microorganisms, such as bacterium, yeast and algal species, can represent an alternative oil source for biodiesel production. The composition of their accumulated lipid is similar to the lipid of an oleaginous plant with a predominance of unsaturated fatty acid. Moreover this alternative to conventional biodiesel production does not create competition for land use between food and oleo-chemical industry supplies. Despite this promising potential, development of microbial production processes are at an early stage. Nutritional limited conditions, such as nitrogen limitation, with an excess of carbon substrate is commonly used to induce lipid accumulation metabolism. Nitrogen limitation implies modification of the carbon-to-nitrogen ratio in culture medium, which impacts on carbon flow distribution in the metabolic network. The goal of the present study is to improve our knowledge of carbon flow distribution in oleaginous yeast metabolism by focusing carbon distribution between carbohydrate and lipid pools in order to optimize microbial lipid production. The dynamic effects of limiting nitrogen consumption flux according to carbon flow were studied to trigger lipid accumulation in the oleaginous yeast Rhodotorula glutinis. With a decrease of the specific nitrogen consumption rate from 0.052 Nmol.CmolX−1.h−1 to 0.003 Nmol.CmolX−1.h−1, a short and transitory intracellular carbohydrate accumulation occurred before the lipid accumulation phase. This phenomenon was studied in fed-batch culture under optimal operating conditions, with a mineral medium and using glucose as carbon source. Two different strategies of decreasing nitrogen flow on carbohydrate accumulation were investigated: an instantaneous decrease and a progressive decrease of nitrogen flow. Lipid production performance in these fed-batch culture strategies with R. glutinis were higher than those reported in the previous literature; the catalytic specific lipid production rate was 0.07 Cmollip.CmolX*−1.h−1. Experimental results suggested that carbohydrate accumulation was an intrinsic phenomenon connected to the limitation of growth by nitrogen when the nitrogen-to-carbon ratio in the feed flow was lower than 0.045 Nmol.Cmol−1. Carbohydrate accumulation corresponded to a 440% increase of carbohydrate content. These results suggest that microbial lipid production can be optimized by culture strategy and that carbohydrate accumulation must be taken account for process design.

1 December 2006 in Journal of Dairy Science
Verified
Journal Article
Open access
PDF file
LFLuc Fillaudeau
Luc Fillaudeau
PWPeter Winterton
Peter Winterton
JLJ.C. Leuliet
J.C. Leuliet
JTJ.P. Tissier
J.P. Tissier
VMV. Maury
V. Maury
FCF. Chopard
F. Chopard
The development of alternative technologies such as the direct Joule effect to pasteurize and sterilize food products is of great scientific and industrial interest. Our objective was 1) to gain insight into the ability to ensure ultra-high-temperature treatment of milk and 2) to investigate the links among thermal, hydraulic, and electrical phenomena in relation to fouling in a direct Joule effect heater. The ohmic heater [OH; E perpendicular to v (where E is the electrical field and v is the velocity); P (power) = 15 kW] was composed of 5 flat rectangular cells [e (space between the plate and electrode) = 15 mm, w (wall) = 76 mm, and L (length of the plate in plate heat exchanger or electrode) = 246 mm]--3 active cells to ensure heating and 2 (at the extremities) for electrical insulation and the recovery of leakage currents. In the first step, the thermal performance of the OH was investigated vs. the flow regimen [50 < Re (Reynolds number) < 5,000], supplied power (0 < P < 15 kW), and electrical conductivity of fluids (0.1 < sigma(20 degrees C) < 2 S/m) under clean conditions with model fluids. This protocol enabled a global thermal approach (thermal and electrical balance, modeling of the temperature profile of a fluid) and local analysis of the wall temperature of the electrode. An empirical correlation was established to estimate the temperature gradient, T(w)-T(b) (where T(w) is the wall temperature and T(b) is the product temperature) under clean conditions (without fouling) and was used to define operating conditions for pure-volume and direct-resistance heating. In the second step, the ability of OH to ensure the ultra-high-temperature treatment of whole milk was investigated and compared with a plate heat exchanger. Special care was taken to investigate the heat transfer phenomena occurring over a range of temperatures from 105 to 138 degrees C. This temperature range corresponds to the part of the process made critical by protein and mineral fouling. The objectives were 1) to demonstrate the ability of an OH to ensure heat treatment of milk, 2) to study the thermal and hydraulic performance with an increasing power and temperature difference between the inlet and outlet of the OH, 3) to define and validate a criterion to follow heat dissipation efficiency, and 4) to compare the fouling propensity with the different configurations. A heat dissipation coefficient, Rh(CO), was defined and validated to monitor the fouling propensity through global electrical and thermal parameters. Finally, a numerical simulation was developed to analyze heat profiles (wall, deposit, bulk). Because of an increasing Joule effect in the static deposit, the simulation showed how wall overheating would definitively cause fouling to spiral out of control.

29 June 2024 in Plants
Verified
Journal Article
Open access
PDF file
Amel ChammamAmel Chammam
Amel Chammam
LFLuc Fillaudeau
Luc Fillaudeau
MRMehrez ROMDHANE
Mehrez ROMDHANE
Jalloul BouajilaJalloul Bouajila
Jalloul Bouajila
Various parts of the Pinaceae species, a traditional plant, have potential health benefits and exhibit antibacterial, anti-cancer, and antioxidant activities. This study aims to investigate the biochemical properties of both petal (P) and core (C) fractions from pinecones of P. halepensis (PA), P. brutia (PB), and P. pinea (PP). Pinecones were manually separated into P and C, which were then milled to investigate maceration with solvents of increasing polarity: cyclohexane (1SV), ethyl acetate (2SV), and methanol (3SV) at 20 °C. Spectrophotometry was utilized to quantify the total phenolic content (TPC) and to assess bioactivities. Gas chromatography with mass spectrometry (GC-MS) and high-performance liquid chromatography (HPLC) were employed to identify the chemical composition. 3SV extracts demonstrated the highest TPC and a significant anti–oxidant potential. PA-P-3SV exhibited the highest TPC (460.66 mg GAE/g DW) and PP-P-3SV displayed the best IC50 (10.54 µg/mL) against DPPH. 1SV and 2SV extracts showed interesting anticancer activity against Hela and HepG2 cells. No significant toxic effect of P and C extracts from pinecones was observed on HEK-293 cells. GC-MS analysis unveiled 46 volatile compounds, of which 32 were detected for the first time in these species. HPLC analysis identified 38 compounds, of which 27 were not previously detected in these species. This study highlights the significant potential of pinecones as a rich source of bioactive compounds.

9 November 2024 in Molecules
Verified
Journal Article
Open access
PDF file
Amel ChammamAmel Chammam
Amel Chammam
MRMehrez ROMDHANE
Mehrez ROMDHANE
LFLuc Fillaudeau
Luc Fillaudeau
Jalloul BouajilaJalloul Bouajila
Jalloul Bouajila
Pinus species are notable in Mediterranean regions due to their ecological and economic importance. Various parts of these species are widely used in traditional medicine, especially pinecones, which are a significant source of bioactive compounds. The current study aimed to evaluate the phytochemical composition and biological properties of the aqueous extracts obtained by maceration from three Pinus petal fractions, from P. halepensis Mill., P. brutia Ten., and P. pinea L. (APW, BPW, and PPW respectively), and the core fractions of the same species (ACW, BCW, and PCW respectively). The results showed that APW demonstrated superior performance compared to other species and fractions (p ≤ 0.05), with the highest total polyphenol content (203.51 mg GAE/g DW) and the highest antioxidant potential (IC50 = 13.51 µg/mL) against DPPH free radical. All extracts showed high anticancer activity against HeLa and HepG2 cancer cell lines, and low inhibition against HEK-293, a normal cell line (<15%), indicating that none of extracts have any toxicity effect. Furthermore, only APW exhibits a significant inhibition against α-glucosidase with 77.20% at 50 µg/mL. HPLC-DAD analysis was conducted to identify 14 compounds. GC-MS analysis was conducted to identify 28 compounds, of which 11 were detected for the first time in this species. This study offers valuable insights into phytochemistry and potential therapeutic applications of pinecones.

3 June 2021 in Processes
Verified
Journal Article
Open access
PDF file
TNTien Cuong Nguyen
Tien Cuong Nguyen
LFLuc Fillaudeau
Luc Fillaudeau
DADominique Anne-Archard
Dominique Anne-Archard
KCKy Son Chu
Ky Son Chu
LNL Nga
L Nga
VNVan Hung Nguyen
Van Hung Nguyen
The effect of particle size on enzymatic hydrolysis of cassava flour at subgelatinization temperature was investigated. A multiscale physical metrology was developed to study the evolution of different physical-biochemical parameters: rheology, granulometry, and biochemistry. In this study, four fractions of cassava flour based on the particle sizes under 75 µm (CR075), 75–125 µm (CR125), 125–250 µm (CR250), and 250–500 µm (CR500) were screened for enzymatic hydrolysis effect. The results showed that all cassava flour suspensions exhibited a shear-thinning behavior, and the viscosity increased drastically with the increase of particle size. During hydrolysis, the viscosity reduced slightly and the non-Newtonian behavior became negligible beyond 4 h of the process. The particles size for CR075 and CR125 increased steadily in diameter mean. The samples of CR250 and CR500 showed more fluctuation by first decreasing, followed by increasing in particle sizes during the process. The highest hydrolysis yield was found for samples with particle size under 125 µm (89.5–90.7%), suggesting that mechanical treatment of cassava can enhance the bioconversion rate.

24 September 2013 in Oil & Gas Science and Technology – Revue d’IFP Energies nouvelles
Verified
Journal Article
Open access
PDF file
MBM. Babau
M. Babau
JCJ. Cescut
J. Cescut
YAY. Allouche
Y. Allouche
ILI. Lombaert-Valot
I. Lombaert-Valot
LFLuc Fillaudeau
Luc Fillaudeau
CMC. Molina-Jouve
C. Molina-Jouve