An approach to automatically generate a dynamic energy simulation model in Modelica for a single existing building is presented. It aims at collecting data about the status quo in the preparation of energy retrofits with low effort and costs. The proposed method starts from a polygon model of the outer building envelope obtained from photogrammetrically generated point clouds. The open-source tools TEASER and AixLib are used for data enrichment and model generation. A case study was conducted on a single-family house. The resulting model can accurately reproduce the internal air temperatures during synthetical heating up and cooling down. Modelled and measured whole building heat transfer coefficients (HTC) agree within a 12% range. A sensitivity analysis emphasises the importance of accurate window characterisations and justifies the use of a very simplified interior geometry. Uncertainties arising from the use of archetype U-values are estimated by comparing different typologies, with best- and worst-case estimates showing differences in pre-retrofit heat demand of about ±20% to the average; however, as the assumptions made are permitted by some national standards, the method is already close to practical applicability and opens up a path to quickly estimate possible financial and energy savings after refurbishment.
31 August 2016 in International Journal of Engine Research
This work presents a scalable model of a naturally aspirated gasoline engine forecasting the effective efficiency map for varying cylinder displacements. Engine test bench measurements and a global nonlinear hybrid optimization method were used to calibrate the engine model. The validation showed a good prediction of engine efficiency by the scaling model with a mean error of 2% compared with the measurements. A pure scaling of the cylinder displacement led to overall small changes in the effective engine efficiency map. In addition to the development of a scalable engine model, a forward-looking hybrid vehicle simulation model was used in order to evaluate the impact of different engine cylinder displacements on fuel consumption. For this purpose, simulations for varying cylinder displacements were performed in a series–parallel hybrid drivetrain of an A-class vehicle in two driving cycles. The simulation results showed a small influence of different engine cylinder displacements on fuel consumption for the given configuration.
Existing buildings often have low energy efficiency standards. For the preparation of retrofits, reliable high-quality data about built-in materials is required. Contactless measuring technologies, especially microwave radar, have the potential to enable an easy-to-apply and automatable way to analyse the structures and thermal properties of existing building walls, but the relationship between materials, their thermal properties, and their electromagnetic properties, such as the permittivity, is needed for its application. This article presents an analysis of the relationship between electromagnetic and thermal properties for a variety of building materials. Systematic measurements were performed for samples (burnt clay bricks, calcium silicate bricks, autoclaved aerated concrete and lightweight concrete) mainly originating from demolished buildings. The thermal conductivity, thermal capacitance, and dielectric permittivity were measured and the hypothesis of a correlation between permittivity and thermal parameters was partly confirmed. This information is a prerequisite for using microwave radar sensing technology to determine heat transfer coefficients of existing building walls. The next research step is the development of a corresponding measurement and evaluation method.