Entangled metallic wire material (EMWM) can be utilized as a novel elastic element in vibration isolation devices for mechanical actuators. This paper presents a vibration experiment aimed at investigating the degradation behavior of mechanical performance in EMWM under a cyclic compressive environment. An electric vibration testing system, coupled with an isolation structure, is employed to apply compressive loads to the EMWM specimens. Through visual observations and quasi-static compression tests, the variations in geometric morphology and mechanical properties are studied, considering different relative densities and vibrational stress amplitudes. The results indicate a significant reduction in the compressed dimension of the specimens as the number of cycles increases, without any wire fractures or wear. The mechanical properties exhibit an increasing secant modulus and a decreasing loss factor. These variations ultimately lead to a gradual deviation of the vibration characteristics of the isolation structure from its design state, including resonance frequency and transmission rate. To forecast the mechanical property degradation of EMWM, prediction models are proposed, incorporating its dimensions, modulus, and damping by fitting the experiment results. This research provides valuable experimental data and presents an effective method to determine the operational lifespan of vibration isolators utilizing EMWM.
Impact dampers or vibration systems with gaps are common in engineering applications, and the impact effects introduced by the gaps make such systems strongly nonlinear. In this paper, a model with an elastic stop is established, considering the stiffness and damping characteristics of the stop, which is a novel kind of impact damper and can be applied in a rotor system. The amplitude–frequency and phase–frequency response of the system at different gaps are obtained by the harmonic balance method with the alternating frequency–time scheme (HBM-AFT). The stability of the periodic solution is analyzed by the Floquet theory, and the time history and frequency spectra of the unstable point are analyzed by the numerical integration method. In the results, there can be more than one steady-state response at unstable points for a given excitation frequency, and the jump phenomenon occurs. The elastic stop is effective in the vibration amplitude suppression if its stiffness has been designed properly. This study provides an insight into the dynamic responses and its applications of the system with gaps, which is guidance for the analysis of pedestal looseness faults and vibration suppress methods.
The paper aims at performing a comprehensive experimental study on the peculiar properties of a bolted joint, and investigates the damping induced at different interfaces (between flanges, bolt head/nut and flange, threads) during vibrations. A novel, simplified, single-bolt system joining a two-beam structure is designed and tested. Experimental results under different boundary conditions are presented, and the influence of the harmonic excitation force, as well as the bolt tension, is investigated. The test results show how the contact interface between the clamped flanges plays an important role in terms of frictional damping provided to the system during vibration, while the contact interfaces between the head/nut and flange, and secondarily between the threads, affect the system response at a less, but not negligible, extent. The test setup and test procedure can provide a database to validate single bolt contact models to be included in a more complex structure.
About Me
School of Energy and Power Engineering, Beihang University, Beijing 100191, PR China
School of Energy and Power Engineering, Beihang University, Beijing 100191, PR China