Alexander Abramovitz

Dr. Alexander Abramovitz

orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2014 in Electronics Letters
Verified
Journal Article
Open access
PDF file
AAAlexander Abramovitz
Alexander Abramovitz
JYJia Yao
Jia Yao
KSKeyue Smedley
Keyue Smedley
A family of single‐switch SEPIC‐derived converters, which apply a tapped inductor (TI), a charge pump (CP) and an inductorless regenerative snubber to attain a high DC step‐up at high efficiency is introduced. The proposed converter family has the advantage of continuous input current, which can be helpful in attaining accurate tracking of the maximum power point of solar panels. The feasibility of the proposed topology is verified by simulation and experimental results.

12 March 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
AAAlexander Abramovitz
Alexander Abramovitz
MSMoshe Shvartsas
Moshe Shvartsas
Alon KupermanAlon Kuperman
Alon Kuperman
The letter concerns a clamped-type passive magnetic energy harvester (MEH), supplying power to a general load via a diode bridge rectifier (DBR). It is known that a certain value of output MEH voltage (referred to as optimal) maximizes harvested power. Under high primary current magnitudes, the optimal voltage value is constant, i.e., current-independent. Consequently, it was recently proposed to interface a passive MEH to a general load via a switching power converter whose input (i.e., MEH-side) voltage is regulated to a corresponding constant voltage reference, realizing the maximum power point reaching (MPPR) method. However, optimal voltage value becomes current-dependent under low primary current magnitudes. As a result, the power harvested by MPPR-operated MEH becomes suboptimal if the MEH-side voltage reference of the converter remains unchanged. Hence, the brief suggests allowing the converter input voltage reference value to be adjusted (by, e.g., a maximum power point tracking loop) to maximize harvested MEH power under low primary currents as well. Experimental results comparing the harvested power of a passive MEH under classical and enhanced MPPR methods validate the proposed enhancement.

5 January 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
AAAlexander Abramovitz
Alexander Abramovitz
MSMoshe Shvartsas
Moshe Shvartsas
Alon KupermanAlon Kuperman
Alon Kuperman
The letter concerns clamped-type magnetic energy harvesters (MEH), supplying power to constant voltage (CV) loads via a diode rectifier. Presented analysis suggests that if primary current magnitude reflected to the secondary side is much higher than core saturation current, then optimal (in terms input MEH power maximization) transfer window length and corresponding load voltage-per-turn ratio become independent of primary current. As a result, certain unique value of load voltage maximizes the power of a given MEH irrespective of primary current magnitude. Moreover, mean magnetic flux path length, B–H curve shape and permeability of the core have no effect on either optimal load voltage-per-turn ratio or maximum harvested power under the above circumstances. Experimental results of MEH capable of harvesting 173 W from a conductor carrying 250 A rms validate the revealed findings.

16 October 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
AAAlexander Abramovitz
Alexander Abramovitz
SBShmuel (Sam) Ben-Yaakov
Shmuel (Sam) Ben-Yaakov
a SPICE model for estimating and simulating core losses of a ferrite magnetic device is presented. The approach is based on a proposed Revised Generalized Steinmetz Equation (RGSE) and requires only the use of the Steinmetz coefficients and core geometry data. The paper presents a RGSE based SPICE simulation strategy that can both estimate and simulate the effect of the core losses on the circuit. Primary advantages RGSE approach are that it does not require switching frequency data and is applicable to arbitrary excitation and not just sinusoidal excitation as the Steinmetz Equation (SE) approximation does. RGSE model is also insensitive to DC bias, this is an improvement over the earlier model. Comparison of previously reported measured and calculated core loss values with the simulation results of the presented SPICE RGSE model, shows excellent agreement in the sinusoidal case and good agreement in the rectangular pulse case.

11 October 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
JYJia Yao
Jia Yao
KZKaisheng Zheng
Kaisheng Zheng
AAAlexander Abramovitz
Alexander Abramovitz
Equivalence between the switched inductor boost (SIB) converter and the tapped inductor boost (TIB) converter is suggested and the required conditions are derived. Based on the equivalence conditions, it is further shown that dynamic model of the SIB converter is merely a private case of the more general TIB converter. The model is derived using the tapped inductor switcher switched flow graph modeling approach. Simulation and experimental results are also reported.

8 October 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
AAAlexander Abramovitz
Alexander Abramovitz
MSMoshe Shvartsas
Moshe Shvartsas
GOGeorgios Ioannou Orfanoudakis
Georgios Ioannou Orfanoudakis
Alon KupermanAlon Kuperman
Alon Kuperman
This paper provides a methodology for deriving a family of output characteristics (DC-side I-V and P-V curves) for a passive magnetic energy harvester (MEH) clamped on a sinusoidal current-carrying conductor. It is demonstrated that MEH characteristics depend on primary current magnitude and frequency as well on load voltage. First, expressions for power harvested by a MEH are derived employing nonlinear B-H curve approximation of the core. Then, conversion losses are assessed to provide respective estimates for the power provided by the MEH to the load. Presented analytical findings are accurately supported by experimental results of MEH designed to harvest up to 240W from a conductor carrying currents of up to 350A.