For optics used in high-power laser beams, high accuracy requirements in full spatial frequency must be fulfilled. Among them, the allowable root mean square value is less than 5 nm in the PSD1 band. In order to evaluate the dynamic performance of the spindle system and put forward a quantitative index, a novel accurate model of the spindle system was built and a series of dynamic simulations were performed. Harmonic response analysis reveals natural frequencies and frequency response functions. Transient analysis indicates vibration waveforms of the tool-tip. Furthermore, by analyzing surface topography, it can be found that the medium-frequency waviness in the machined surface matches the vibration waveform. Obviously, the medium-frequency waviness is generated by the modal vibration of the spindle system. So that a quantitative index for the aerostatic spindle is proposed: when the amplitude of vibration in transient analysis is smaller than 8 nm, the allowable error in the PSD1 band can be fulfilled.

The waviness errors on the machined surfaces have significant impact on the performance of optical components. Mid-spatial frequency errors (amplitude near 10 nm, wavelength about 1 mm) are found on the machined surfaces along feeding direction, and the oil pressure fluctuations of the hydrostatic slide are confirmed to be the main source which produces such waviness errors. In this article, the influence of oil pressure fluctuations on the machined surface is studied quantitatively for the first time, and the corresponding experiments are carried out. Besides, the three-dimensional surface profile simulations of workpieces considering the oil pressure fluctuations are achieved. The simulation results have been verified by the experiments on an ultra-precision flycutting machine.

In the field of ultra-precision machining, the dynamic performance of ultra-precision equipment contributes a lot to the processing accuracy. In this paper, in order to study the dynamic performance of the flycutting machine tool, the virtual material method was adopted creatively to build a machine tool model. This method overcame the complexity of actual structure and obtained more accurate results than traditional methods. Subsequently, the finite element method was applied to analyze the dynamic performance of the virtual material model. Furthermore, the modal test for the flycutting machine tool was performed to verified the simulations by means of the one-point hitting and multi-point measurement. The simulation results indicate that the virtual material model has high comprehensive accuracy, of which the average error of natural frequency is 5.9% and errors are all less than 6% excepting the first order. Moreover, combined with the flycutting experiments, it can be found that the fifth order mode of machine tool contributes a lot to processing quality, which leads to the waviness of 53 mm on the machined surface directly because of the weak stiffness of beam-column joints. By increasing the stiffness of the key joints, the waviness can be eliminated, which greatly improves the surface quality of the workpiece.

As an important nonlinear optical material, potassium dihydrogen phosphate (KDP) crystal is used in high-power laser beams as the core element of inertial confinement fusion. It is the most general method of single point diamond fly-cutting (SPDF) to produce high precision and crack-free KDP surfaces. Nevertheless, the cutting mechanism of such material remains unclear, and therefore needs further analysis. Firstly, the stress field, cutting force and cutting temperature under different working conditions are calculated by a KDP crystal cutting simulation model. Then, the rules and the cause of change and interaction mechanisms of force and temperature are analyzed by comparing the measurement experiments with simulations. Furthermore, the causes of chip formation and micro-cracks on the machined surface are analyzed based on thermo-mechanical coupling and chip morphology. The conclusion can be deduced: Although the temperature has not reached the phase transition temperature during the finishing process, under high cutting speeds and large unformed chip thickness, such as semi-finishing and roughing, the temperature can reach up to 180 °C or higher, and KDP crystals are very likely to phase transition—chip morphology also verifies this phenomenon.