Sorb Yesudhas

Dr. Sorb Yesudhas

Department of Aerospace Engineering, Iowa State University, Ames, IA 50011, USA
orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 August 2024 in Nature Communications
Verified
Journal Article
Open access
PDF file
Sorb YesudhasSorb Yesudhas
Sorb Yesudhas
VLValery I. Levitas
Valery I. Levitas
FLFeng Lin
Feng Lin
KPK. K. Pandey
K. K. Pandey
JSJesse S. Smith
Jesse S. Smith
Pressure-induced phase transformations (PTs) in Si, the most important electronic material, have been broadly studied, whereas strain-induced PTs have never been studied in situ. Here, we reveal in situ various important plastic strain-induced PT phenomena. A correlation between the direct and inverse Hall-Petch effect of particle size on yield strength and pressure for strain-induced PT is predicted theoretically and confirmed experimentally for Si-I→Si-II PT. For 100 nm particles, the strain-induced PT Si-I→Si-II initiates at 0.3 GPa under both compression and shear while it starts at 16.2 GPa under hydrostatic conditions. The Si-I→Si-III PT starts at 0.6 GPa but does not occur under hydrostatic pressure. Pressure in small Si-II and Si-III regions of micron and 100 nm particles is ∼5–7 GPa higher than in Si-I. For 100 nm Si, a sequence of Si-I → I + II → I + II + III PT is observed, and the coexistence of four phases, Si-I, II, III, and XI, is found under torsion. Retaining Si-II and single-phase Si-III at ambient pressure and obtaining reverse Si-II→Si-I PT demonstrates the possibilities of manipulating different synthetic paths. The obtained results corroborate the elaborated dislocation pileup-based mechanism and have numerous applications for developing economic defect-induced synthesis of nanostructured materials, surface treatment (polishing, turning, etc.), and friction.

12 July 2023 in Materials Research Letters
Verified
Journal Article
Open access
FLFeng Lin
Feng Lin
VLValery I. Levitas
Valery I. Levitas
KPKrishan K. Pandey
Krishan K. Pandey
Sorb YesudhasSorb Yesudhas
Sorb Yesudhas
CPChangyong Park
Changyong Park

6 March 2024 in Research Square
Verified
Preprint
Open access
PDF file
Sorb YesudhasSorb Yesudhas
Sorb Yesudhas
VLValery I. Levitas
Valery I. Levitas
FLFeng Lin
Feng Lin
KPK. K. Pandey
K. K. Pandey
JSJesse S. Smith
Jesse S. Smith
Pressure-induced phase transformations (PTs) in Si, the most important electronic material, have been broadly studied. However, strain-induced PTs in Si were never studied in situ. Here, we revealed in situ various important plastic strain-induced PT phenomena. A correlation between the particle size's direct and inverse Hall-Petch effect on yield strength and pressure for strain-induced PT is found. For 100 nm particles, strain-induced PT Si-I→Si-II initiates at 0.3 GPa versus 16.2 GPa under hydrostatic conditions; Si-I→Si-III PT starts at 0.6 GPa and does not occur under hydrostatic pressure. Pressure in small Si-II and Si-III regions is ~5-7 GPa higher than in Si-I. Retaining Si-II and single-phase Si-III at ambient pressure and obtaining reverse Si-II→Si-I PT demonstrates the possibilities of manipulating different synthetic paths. The obtained results corroborate the elaborated dislocation pileup-based mechanism and have numerous applications for developing economic defect-induced synthesis of nanostructured materials, surface treatment (polishing, turning, etc.), and friction.

2 December 2025 in arXiv
Verified
Preprint
Open access
PDF file
Sorb YesudhasSorb Yesudhas
Sorb Yesudhas
MSMrinmay Sahu
Mrinmay Sahu
VLValery I. Levitas
Valery I. Levitas
DSDean Smith
Dean Smith
JLJeffrey T. Lloyd
Jeffrey T. Lloyd
The first experiments in dynamic rotational diamond anvil cell (dRDAC) on severe plastic deformation (SPD) and BCC<->HCP phase transformation (PT) at pressure up to 27.6 GPa, rotation rates up to 1,500 RPM, and strain rates up to 2,094 /s are performed considering Fe-%7Mn alloy as an example. The BCC-HCP PT initiates at 11.4 GPa under hydrostatic loading while it is 3.2 GPa under plastic compression. Strong effect of plastic straining leads to unique kinetics with simultaneous direct and reverse PTs, not studied for any material. For quasi-static loading, parameters in the kinetics for the strain-induced direct-reverse PTs and stationary volume fraction versus pressure are found. During torsion with 1,000 and 1,500 RPM, volume fraction of the HCP phase does not change. After torsion stops, it increases by 30% within a few minutes after 1,000 RPM and HCP phase disappears after 1,500 RPM. These findings contradict general wisdom that strain-induced PTs occur only during straining, time is not a governing parameter, and kinetics is determined by plastic strain instead of time. Thus, nuclei of the HCP phase are generated during straining at high strain rate, but growth/disappearance occur under stresses at much longer time scales. Consequently, a new theory of combined strain- and stress-induced PTs is required. The following important rule is revealed: crystallite size of 30 nm, microstrain ~0.004, and dislocation density ~1.1 x $10^{15}$/$m^2$ in the HCP phase are steady during static compression and dynamic torsion, during and after the PT and after torsion. These parameters are independent of pressure, plastic strain tensor, its path, strain rates, and volume fraction of the HCP phase. Obtained results open fundamental research on combined strain- and stress-induced PTs and microstructure evolution under dynamic SPD and high pressure.

23 February 2024 in arXiv
Verified
Preprint
Open access
PDF file
Sorb YesudhasSorb Yesudhas
Sorb Yesudhas
VLValery I. Levitas
Valery I. Levitas
FLFeng Lin
Feng Lin
KPK. K. Pandey
K. K. Pandey
MSMaddury Somayazulu
Maddury Somayazulu
High-pressure synchrotron X-ray diffraction (XRD) studies have been conducted on three types of Si particles (micron, 100 nm, and 30 nm). The pressure for initiation of Si-I->Si-II phase transformation (PT) essentially increases with a reduction in particle size. For 30 nm Si particles, Si-I directly transforms to Si-XI by skipping the intermediate Si-II phase, which appears during the pressure release. The evolution of phase fractions of Si particles under hydrostatic compression is studied. The equation of state (EOS) of Si-I, Si-II, Si-V, and Si-XI for all three particle sizes is determined, and the results are compared with other studies. A simple iterative procedure is suggested to extract the EOS of Si-XI and Si-II from the data for a mixture of two and three phases with different pressures in each phase. Using previous atomistic simulations, EOS for Si-II is extended to ambient pressure, which is important for plastic strain-induced phase transformations. Surprisingly, the EOS of micron and 30 nm Si are identical, but different from 100 nm particles. In particular, the Si-I phase of 100 nm Si is less compressible than that of micron and 30 nm Si. The reverse Si-V->Si-I PT is observed for the first time after complete pressure release to the ambient for 100 nm particles.

8 March 2023 in arXiv
Verified
Preprint
Open access
PDF file
Sorb YesudhasSorb Yesudhas
Sorb Yesudhas
VLValery I. Levitas
Valery I. Levitas
FLFeng Lin
Feng Lin
KPK. K. Pandey
K. K. Pandey
JSJesse Smith
Jesse Smith
Pressure-induced phase transformations (PTs) between numerous phases of Si, the most important electronic material, have been studied for decades. This is not the case for plastic strain-induced PTs. Here, we revealed in-situ various unexpected plastic strain-induced PT phenomena. Thus, for 100 nm Si, strain-induced PT Si-I to Si-II (and Si-I to Si-III) initiates at 0.4 GPa (0.6 GPa) versus 16.2 GPa ($\infty$, since it does not occur) under hydrostatic conditions; for 30 nm Si, it is 6.1 GPa versus $\infty$. The predicted theoretical correlation between the direct and inverse Hall-Petch effect of the grain size on the yield strength and the minimum pressure for strain-induced PT is confirmed for the appearance of Si-II. Retaining Si-II at ambient pressure and obtaining reverse Si-II to Si-I PT are achieved, demonstrating the possibilities of manipulating different synthetic paths.