Group V elements in crystal structure isostructural to black phosphorus with unique puckered two-dimensional layers exhibit exciting physical and chemical phenomena. However, as the first element of group V, nitrogen has never been found in the black phosphorus structure. Here, we report the synthesis of the black phosphorus–structured nitrogen at 146 GPa and 2200 K. Metastable black phosphorus–structured nitrogen was retained after quenching it to room temperature under compression and characterized in situ during decompression to 48 GPa, using synchrotron x-ray diffraction and Raman spectroscopy. We show that the original molecular nitrogen is transformed into extended single-bonded structure through gauche and trans conformations. Raman spectroscopy shows that black phosphorus–structured nitrogen is strongly anisotropic and exhibits high Raman intensities in two Ag normal modes. Synthesis of black phosphorus–structured nitrogen provides a firm base for exploring new type of high-energy-density nitrogen and a new direction of two-dimensional nitrogen.
Determining the unreacted equation of state of 1,3,5-triamino-2,4,6-trinitrobenzene (TATB) is challenging because it exhibits low crystal symmetry and low X-ray scattering strength. Here, we present the first high-pressure single-crystal X-ray diffraction (SXD) study of this material. Our SXD results reveal a previously unknown transition to a monoclinic phase above 4 GPa. No abrupt change of the volume occurs but the compressibility changes. Concomitant first principles evolutionary crystal structure prediction USPEX calculations confirm this transition and show that it involves a pressure-induced in-plane shift of the layers of TATB molecules with respect to the ambient-pressure phase.
Pressure-induced phase transformations (PTs) in Si, the most important electronic material, have been broadly studied, whereas strain-induced PTs have never been studied in situ. Here, we reveal in situ various important plastic strain-induced PT phenomena. A correlation between the direct and inverse Hall-Petch effect of particle size on yield strength and pressure for strain-induced PT is predicted theoretically and confirmed experimentally for Si-I→Si-II PT. For 100 nm particles, the strain-induced PT Si-I→Si-II initiates at 0.3 GPa under both compression and shear while it starts at 16.2 GPa under hydrostatic conditions. The Si-I→Si-III PT starts at 0.6 GPa but does not occur under hydrostatic pressure. Pressure in small Si-II and Si-III regions of micron and 100 nm particles is ∼5–7 GPa higher than in Si-I. For 100 nm Si, a sequence of Si-I → I + II → I + II + III PT is observed, and the coexistence of four phases, Si-I, II, III, and XI, is found under torsion. Retaining Si-II and single-phase Si-III at ambient pressure and obtaining reverse Si-II→Si-I PT demonstrates the possibilities of manipulating different synthetic paths. The obtained results corroborate the elaborated dislocation pileup-based mechanism and have numerous applications for developing economic defect-induced synthesis of nanostructured materials, surface treatment (polishing, turning, etc.), and friction.
Diamond anvil cell techniques have been improved to allow access to the multimegabar ultrahigh-pressure region for exploring novel phenomena in condensed matter. However, the only way to determine crystal structures of materials above 100 GPa, namely, X-ray diffraction (XRD), especially for low Z materials, remains nontrivial in the ultrahigh-pressure region, even with the availability of brilliant synchrotron X-ray sources. In this work, we perform a systematic study, choosing hydrogen (the lowest X-ray scatterer) as the subject, to understand how to better perform XRD measurements of low Z materials at multimegabar pressures. The techniques that we have developed have been proved to be effective in measuring the crystal structure of solid hydrogen up to 254 GPa at room temperature [C. Ji et al., Nature 573, 558–562 (2019)]. We present our discoveries and experiences with regard to several aspects of this work, namely, diamond anvil selection, sample configuration for ultrahigh-pressure XRD studies, XRD diagnostics for low Z materials, and related issues in data interpretation and pressure calibration. We believe that these methods can be readily extended to other low Z materials and can pave the way for studying the crystal structure of hydrogen at higher pressures, eventually testing structural models of metallic hydrogen.
We have measured the luminescence shifts of the ruby’s R1- and R2-lines and the line of 5D0→7F0 from Sm2+:SrFCl corresponding to the melting pressure of mercury that is recommended by the AIRAPT task force as an International Practical Pressure Scale (IPPS). The linear coefficients of the pressure dependence of the R1-, R2-lines, and the luminescence line of Sm2+:SrFCl are determined to be 0.3722 ± 0.002, 0.3796 ± 0.002, and 1.123 ± 0.002 nm/GPa, respectively. The results not only put tight constraints on the initial slopes of ruby and Sm2+:SrFCl gauges, but also link the luminescence-based pressure gauges to the more fundamental primary piston gauges.