Nathaporn Promros

Nathaporn Promros


Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 May 2016 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
NPNathaporn Promros
Nathaporn Promros
RBRyuji Baba
Ryuji Baba
MTMotoki Takahara
Motoki Takahara
TMTarek M. Mostafa
Tarek M. Mostafa
PSPhongsaphak Sittimart
Phongsaphak Sittimart
TYTsuyoshi Yoshitake
Tsuyoshi Yoshitake
β-FeSi2 thin films were epitaxially grown on p-type Si(111) substrates at a substrate temperature of 560 °C and Ar pressure of 2.66 × 10−1 Pa by radio-frequency magnetron sputtering (RFMS) using a sintered FeSi2 target, without postannealing. The resultant n-type β-FeSi2/p-type Si heterojunctions were evaluated as near-infrared photodiodes. Three epitaxial variants of β-FeSi2 were confirmed by X-ray diffraction analysis. The heterojunctions exhibited typical rectifying action at room temperature. At 300 K, the heterojunctions showed a substantial leakage current and minimal response for irradiation of near-infrared light. At 50 K, the leakage current was markedly reduced and the ratio of the photocurrent to dark current was considerably enhanced. The detectivity at 50 K was estimated to be 3.0 × 1011 cm Hz1/2/W at a zero bias voltage. Their photodetection was inferior to those of similar heterojunctions prepared using facing-target direct-current sputtering (FTDCS) in our previous study. This inferiority is likely because β-FeSi2 films prepared using RFMS are located in plasma and are damaged by it.

1 August 2021 in Coatings
Verified
Journal Article
Open access
PDF file
NBNattakorn Bฺorwornpornmetee
Nattakorn Bฺorwornpornmetee
PCPeerasil Charoenyuenyao
Peerasil Charoenyuenyao
RCRawiwan Chaleawpong
Rawiwan Chaleawpong
BPBoonchoat Paosawatyanyong
Boonchoat Paosawatyanyong
RPRungrueang Phatthanakun
Rungrueang Phatthanakun
NPNathaporn Promros
Nathaporn Promros
Fe3Si films are deposited onto the Si(111) wafer using sputtering with parallel facing targets. Surface modification of the deposited Fe3Si film is conducted by using a microwave plasma treatment under an Ar atmosphere at different powers of 50, 100 and, 150 W. After the Ar plasma treatment, the crystallinity of the coated Fe3Si films is enhanced, in which the orientation peaks, including (220), (222), (400), and (422) of the Fe3Si are sharpened. The extinction rule suggests that the B2–Fe3Si crystallites are the film’s dominant composition. The stoichiometry of the Fe3Si surfaces is marginally changed after the treatment. An increase in microwave power damages the surface of the Fe3Si films, resulting in the generation of small pinholes. The roughness of the Fe3Si films after being treated at 150 W is insignificantly increased compared to the untreated films. The untreated Fe3Si films have a hydrophobic surface with an average contact angle of 101.70°. After treatment at 150 W, it turns into a hydrophilic surface with an average contact angle of 67.05° because of the reduction in the hydrophobic carbon group and the increase in the hydrophilic oxide group. The hardness of the untreated Fe3Si is ~9.39 GPa, which is kept at a similar level throughout each treatment power.

1 September 2012 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
NPNathaporn Promros
Nathaporn Promros
KYKyohei Yamashita
Kyohei Yamashita
SIShota Izumi
Shota Izumi
RIRyūhei Iwasaki
Ryūhei Iwasaki
MSMahmoud Shaban
Mahmoud Shaban
TYTsuyoshi Yoshitake
Tsuyoshi Yoshitake
N-Type β-FeSi2/intrinsic Si/p-type Si heterojunction photodiodes were fabricated by facing-targets direct-current sputtering, and their infrared photodetection properties were studied at low temperatures. The rectification current ratio at bias voltages of ±1 V and the ratio of the photocurrent to the dark leakage current were dramatically enhanced with a decrease in temperature. The specific detectivities at 300 and 50 K were estimated to be 3.8×109 and 8.9×1011 cm Hz1/2 W-1, respectively. The enhanced detectivity upon cooling is attributed to the marked reduction in the dark leakage current. The insertion of the thin intrinsic Si layer slightly contributed to the suppression of the leakage current and the detectivity improvement. It was demonstrated that β-FeSi2 is a potential material for Si-compatible near-infrared photodetectors.

18 November 2013 in physica status solidi (c)
Verified
Journal Article
Closed access
PDF file
SFSuguru Funasaki
Suguru Funasaki
NPNathaporn Promros
Nathaporn Promros
RIRyuhei Iwasaki
Ryuhei Iwasaki
MTMotoki Takahara
Motoki Takahara
SMShaban AA Mahmoud
Shaban AA Mahmoud
TYTsuyoshi Yoshitake
Tsuyoshi Yoshitake

30 March 2022 in Materials Science in Semiconductor Processing
Verified
Journal Article
Closed access
PCPeerasil Charoenyuenyao
Peerasil Charoenyuenyao
RCRawiwan Chaleawpong
Rawiwan Chaleawpong
NBNattakorn Borwornpornmetee
Nattakorn Borwornpornmetee
BPBoonchoat Paosawatyanyong
Boonchoat Paosawatyanyong
PSPhongsaphak Sittimart
Phongsaphak Sittimart
NPNathaporn Promros
Nathaporn Promros

24 June 2023 in Materials Science in Semiconductor Processing
Verified
Journal Article
Closed access
NBNattakorn Borwornpornmetee
Nattakorn Borwornpornmetee
RCRawiwan Chaleawpong
Rawiwan Chaleawpong
PCPeerasil Charoenyuenyao
Peerasil Charoenyuenyao
ANAdison Nopparuchikun
Adison Nopparuchikun
BPBoonchoat Paosawatyanyong
Boonchoat Paosawatyanyong
NPNathaporn Promros
Nathaporn Promros