Traditionally, condition monitoring of power semiconductor modules has been based on electrical measurements. Acoustic emission has been utilized for condition monitoring in many other applications, but is an unknown phenomenon in power semiconductor modules. In this paper, the authors present an experimental setup used to show that acoustic emission does occur because of the switching of power semiconductor components. An analysis based on propagation delays is used to determine the source of the acoustic emission.
This paper introduces an alternative implementation of the traditional LC filter, called hybrid LC filter (HLCF). The construction described in this paper contains two foil windings that integrate inductance and capacitance into one unit. The main aspects of the HLCF design are considered. The experimental data show that the device proposed here can be used, instead of traditional LC filters, as an alternative solution for the mitigation of the adverse effects of the pulse-width modulation (PWM).
The authors show for the first time that acoustic events are related to the failure of transistors. An experimental setup is presented, that was used to make a sample of 26 insulated gate bipolar transistors (IGBT) to fail. The acoustic events in the transistors were monitored. It was discovered that two distinct types of acoustic events are related to the failure. This study complements recent work where it was shown that the switching operation of power transistors causes acoustic emissions to take place.
A recent paper showed that the switching operation of a power semiconductor module causes an acoustic emission to take place. In this study, that experiment is repeated using a different kind of acoustic emission sensor. The same conclusion is reached in this stydy as in the previous paper: an acoustic emission takes place as a result of the switching of a power module.
30 October 2020 in IEEE Transactions on Instrumentation and Measurement
Heat flux sensors have potential in enabling applications that require direct and instantaneous tracking of thermal energy transfer. To facilitate widespread use of the sensors, the sensors have to be robust and feasible to implement, while maintaining high sensitivity, fast response time, and low thermal obtrusiveness. However, most currently available heat flux sensors are either challenging to manufacture or ill-suited for surface heat flux measurement because of their mechanical or thermal characteristics. In this paper, the design of a novel MEMS heat flux sensor structure intended for surface heat flux measurements is presented. A prototype batch is manufactured and the electrical performance of the prototype sensors is compared with commercially available heat flux sensors. Results show that sensors with a similar sensitivity as commercial sensors can be made by using MEMS methods.