In order to increase the overall solar energy gain of evacuated tube collectors, rear-side reflectors are used. In this way, the otherwise unused incident radiation between the tubes can be reflected back to the absorber, and the performance of the collector can be improved. In this paper, the use of a low-cost, diffusely reflecting, trapezoidal roof covering made from a galvanized metal sheet is investigated and compared to a high-quality, specularly reflecting plane reflector made of aluminum. For this purpose, ray-tracing analysis and TRNSYS simulations were carried out. In the ray-tracing analysis, the experimentally determined zero-loss collector efficiency η0 as well as the incident angle modifiers for each reflector can be reproduced with an error lower than 7.5%. Thermal system simulations show that the performance of both reflectors is comparable. The use of the low-cost reflector leads to an increase in annual collector output of around 30% compared to an increase with the specular reflector of around 33%. Considering a typical domestic hot water system, both reflectors enable an increase in the solar annual yield of approx. 11%.
26 February 2026 in Solarthermie-Symposium Proceedings
Large-scale solar thermal systems supplying heating networks can make a significant contribution to the decarbonization of the heating sector and are becoming increasingly relevant in practice. The first part of the paper analyses 30 realized systems in Germany focusing on collector area, heat storage capacity and stagnation events. More than 60 % of these systems have heat storage capacities smaller than 100 l/m² collector area. Nevertheless, a third of the systems reaches an annual solar fraction of over 20 %. Our investigations for such dimensioned systems report a number of 20 to 43 stagnation days per year, depending on the storage capacity. The relevance of stagnation load motivates our research activities to avoid its negative consequences in large-scale systems. The second part of the paper describes the development of evacuated tube collectors with inherent overheating prevention as well as the outdoor tests we carried out with various prototypes at our sun tracker. The collector concepts are based on heat pipes with temperature limitation to 125-135 °C in the solar circuit and are therefore able to avoid evaporation of the heat transfer medium. Due to lower stagnation loads, we investigate the possibility of using polymeric pipes instead of steel pipes for the solar circuit and discuss an integrated system concept. The innovative collector and system design are implemented in a demonstration plant that we will monitor during the construction phase and in operation.