Electric Vehicle is now a global term, affecting the transportation sector, automobile industry, and electric grid scenario. As Plug-in Electric Vehicles (PEVs) penetration level is escalating, PEVs will create new challenges and opportunities for transportation and the electric grid in the near future. The distributed stored energy of PEVs with high active power controllability turns PEVs into new distributed energy sources (DES) for the grid. With a high penetration level, PEVs can also provide ancillary services to the grid, e.g., primary frequency control (PFC). Although grid support provided by PEVs is limited because of additional operational limitations and various constraints of PEVs and the grid. A new charging model for PEVs has been proposed in this paper to investigate the potential of PEVs for primary frequency control. The proposed model incorporates several PEV characteristics such as charger topology, drive power limitation, and operational modes with proper consideration of PEV’s charging demand profile. Furthermore, a control scheme is proposed to decide the availability of PEVs for ancillary services and compute the participation level of PEVs without affecting the charging demands. In the end, several scenarios have been used to evaluate and show the potential of PEVs for the PFC in the power system. The maximum deviation of frequency is reduced by 17.39% in case 1 of Scenario A, 26.08% in case 2 of Scenario A and 21.73% in both cases of Scenario B with proper consideration of charging demands. Graphical abstract
The increasing penetration level of electric vehicles (EVs) shows that they will enter into the category of distributed energy sources in the near future. Major upgradation is required in the conventional power system to handle upcoming challenges due to electrification in the transportation sector and generate opportunities for the power system. The energy storage capability of batteries and advancement in fast switching converters enable EVs to support the grid with different ancillary services, e.g. primary frequency control (PFC). However, an effective charging strategy/controller is required to support the grid with PFC without violating constraints from grid and EVs. This paper proposes a novel fuzzy-based controller to decide EV’s availability for PFC with an optimized participation level considering different operational modes and EV charging demand. The controller computes the participation level of EVs based on real-time inputs from EVs, magnitude of frequency deviation and availability of primary reserve. The Spanish power system model has been employed to show the proposed controller’s efficacy and compare it with other recently reported controllers. The MATLAB/Simulink platform has been used to perform frequency and power response analysis for four different defined cases. Results show that EVs with the proposed fuzzy-based controller can effectively support the grid with PFC service without violating the grid’s and EV’s limits. GRAPHICAL ABSTRACT
Electrical Vehicals have the potential to transform the energy sector, bringing with them advantages for sustainability and new chances for grid optimization. However, the stability, reliability, and effectiveness of distribution networks are also put at risk by this transformation. Therefore, it is crucial to perform thorough analysis of how EV integration may affect distribution networks. The vital importance of impact analyses for EV integration into distribution networks is highlighted in this paper. These evaluations are essential for comprehending and controlling the complex impacts of EV charging on the distribution system. The paper also highlights how impact evaluations help with effective infrastructure planning, improving the integration of renewable energy according to regulatory requirements, and making the most use of already existing assets. This paper examines how the EVs adoption affects distribution network based on three important parameters: voltage instability, power losses and reliability. The IEEE 33 bus test system for ten different scenarios is used for the whole investigation. Additionally, a method for placing EV charging stations on distribution networks based on the analysed grid parameters is proposed. The outcomes show that the VRP (Voltage, Reliability and Power loss) is effective to decide the optimize location for charging station.