Michele Oliver

Dr. Michele Oliver

orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 May 2015 in Journal of Hand Surgery (European Volume)
Verified
Journal Article
Closed access
JWJ. F. Weber
J. F. Weber
AAA. M. R. Agur
A. M. R. Agur
AFA. Y. Fattah
A. Y. Fattah
KGK. D. Gordon
K. D. Gordon
MOMichele Oliver
Michele Oliver
Previous studies of the mechanical properties of tendons in the upper limb have used embalmed specimens or sub-optimal methods of measurement. The aim of this study was to determine the biomechanical properties of all tendons from five fresh frozen cadaveric forearms using updated methodology. The cross-sectional area of tendons was accurately measured using a laser reflectance system. Tensile testing was done in a precision servo-hydraulic device with cryo-clamp fixation. We determined that the cross-sectional area of some tendons is variable and directly influences the calculated material properties; visual estimation of this is unreliable. Data trends illustrate that digital extensor tendons possess the greatest tensile strength and a higher Young’s modulus than other tendon types.

27 April 2010 in Ergonomics
Verified
Journal Article
Closed access
RJR. J. Jack
R. J. Jack
MOMichele Oliver
Michele Oliver
James DickeyJames Dickey
James Dickey
SCS. Cation
S. Cation
GHG. Hayward
G. Hayward
NLN. Lee-Shee
N. Lee-Shee
This research focuses on quantifying six-degree-of-freedom (6-DOF) whole-body vibration (WBV) exposure levels that occur in Northern Ontario skidders during routine field operating tasks. 6-DOF vibration running root-mean-square (RMS) acceleration levels at the operator/seat interface were determined for eight skidders while driving loaded, driving unloaded, picking up a load, dropping off a load and ploughing logs under field operating conditions. The acceleration data were weighted in accordance with ISO 2631–1:1997 and evaluated for both health and comfort outcomes. The mean running RMS weighted translational and rotational accelerations all exceeded 0.36 m/s2 and 0.14 rad/s2. The greatest average accelerations occurred while driving unloaded with this condition displaying translational vibration total values (VTV) that exceeded the upper limit of the ISO 2631–1:1997 health caution zone within an average of 2.3 h. Utilizing 6-DOF VTV, virtually all operating conditions would be designated as uncomfortable. Statement of Relevance: This study provides one of the most comprehensive reports on vibration exposures in seated vehicle operators. The results are geared towards ergonomists with discussions on health effects and measurement concerns, while providing the raw vibration exposure data that will be useful to vehicle, component and vibration sensor designers.

13 January 2023 in Sensors
Verified
Journal Article
Open access
PDF file
CYCalvin Young
Calvin Young
AHAndrew Hamilton-Wright
Andrew Hamilton-Wright
MOMichele Oliver
Michele Oliver
KGKaren Gordon
Karen Gordon
Current methods for ergonomic assessment often use video-analysis to estimate wrist postures during occupational tasks. Wearable sensing and machine learning have the potential to automate this tedious task, and in doing so greatly extend the amount of data available to clinicians and researchers. A method of predicting wrist posture from inertial measurement units placed on the wrist and hand via a deep convolutional neural network has been developed. This study has quantified the accuracy and reliability of the postures predicted by this system relative to the gold standard of optoelectronic motion capture. Ten participants performed 3 different simulated occupational tasks on 2 occasions while wearing inertial measurement units on the hand and wrist. Data from the occupational task recordings were used to train a convolutional neural network classifier to estimate wrist posture in flexion/extension, and radial/ulnar deviation. The model was trained and tested in a leave-one-out cross validation format. Agreement between the proposed system and optoelectronic motion capture was 65% with κ = 0.41 in flexion/extension and 60% with κ = 0.48 in radial/ulnar deviation. The proposed system can predict wrist posture in flexion/extension and radial/ulnar deviation with accuracy and reliability congruent with published values for human estimators. This system can estimate wrist posture during occupational tasks in a small fraction of the time it takes a human to perform the same task. This offers opportunity to expand the capabilities of practitioners by eliminating the tedium of manual postural assessment.

30 April 2021 in Ergonomics
Verified
Journal Article
Closed access
ANAlexander J. Nolan
Alexander J. Nolan
MGMegan E. Govers
Megan E. Govers
MOMichele Oliver
Michele Oliver
Whole-body vibration and muscle fatigue have both been shown to delay the trunk muscle reflex response and increase trunk muscle activation, leading to an increased risk of low back injuries. However, the effects of whole-body vibration on previously fatigued trunk muscles have never been tested, despite studies showing that prolonged exposure to whole-body vibration can lead to muscle fatigue. The purpose of this research was to investigate the effects of muscle fatigue on muscle latency, muscle activation and perceived discomfort when exposed to whole-body vibration. The results showed that a fatigued muscle state resulted in increased muscle latency, muscle activation and perceived discomfort, which all escalate the risk of low back injuries. Additionally, the ISO 2631-1 comfort ratings did not increase with fatigue, showing a disconnect between these comfort ratings and the perceived discomfort ratings in a fatigued muscle state. PRACTITIONER SUMMARY: When exposed to whole-body vibration, fatigued back muscles result in delayed muscle contraction, higher overall muscle activation and increased perceived discomfort, all of which are known to increase low back injury risk. ISO 2631-1 comfort ratings are unable to increase with fatigue, showing a disconnect with perceived discomfort ratings.

30 September 2020 in The Canadian Journal for the Scholarship of Teaching and Learning
Verified
Journal Article
Open access
PDF file
JVJulie Vale
Julie Vale
MOMichele Oliver
Michele Oliver
RCRyan M. C. Clemmer
Ryan M. C. Clemmer
A second-year engineering course at the authors’ institution was offered via a blended synchronous learning (BSL) method of delivery whereby students could choose to attend lectures live (face-to-face) or remotely (via a synchronous, live stream over the internet) during a summer semester. Survey and grade data were collected across two years of this offering. Attendance, interaction, communication with the instructor, and general distractions were main themes affecting the student learning experience both positively and negatively. Specifically, students found the remote access, the ability to ask questions, the teaching style, and having more time during the summer semester as positive aspects to their learning experience. Negative influences on their learning experience related primarily to their busy work schedules, technological issues associated with BSL, and typical summer distractions. Critically, our results indicate that attendance is a key indicator of student grades (after correcting for GPA), regardless of whether students attended lectures remotely or face-to-face: students attending more than 75% of the lectures performed on average 12% better than students who did not (p=0.0093). The consensus in the student comments was that the remote attendance option allowed students to attend in situations where the alternative was no attendance at all, implying that the potential gain in grades due to higher attendance may outweigh any potential impact the mode of attendance may have. Overall, a synchronous, remote attendance option may provide a lifeline to students who would not otherwise be able to attend a course, and (assuming a mode of interaction, such as the synchronous chat, is available) students do not perceive remote attendance as having a negative influence on their learning.

5 July 2022 in Applied Ergonomics
Verified
Journal Article
Closed access
RWRebecca Wendland
Rebecca Wendland
LBLinda Bossi
Linda Bossi
MOMichele Oliver
Michele Oliver