Low mechanical strength of calcium phosphate cement (CPC) limits its clinical application as a bone replacement. Herein, for the first time, we selected bacterial cellulose (BC) fibres to reinforce CPC. The BC-reinforced CPC (BC/CPC) composites with varying BC content were prepared and compared in terms of microstructure, compressive strength and cellular responses. Scanning electron microscope (SEM) images revealed the uniform dispersion of BC in CPC matrix. Fourier-transform infrared spectroscopy (FTIR) and X-ray photoelectron spectroscopy (XPS) results confirmed the interfacial coordination interaction between BC and CPC. It was found that the introduction of BC enhanced the compressive strength of CPC, and the optimal BC content was 2 wt.%. Moreover, cell studies showed that BC/CPC composites exhibited better cell performance than bare CPC. The results have demonstrated that a new CPC composite with enhanced mechanical performance and cellular responses may be developed by using BC as reinforcement.
In this study, the isothermal crystallization process of poly(l-lactide) (PLLA) has been investigated using in situ XRD, differential scanning calorimetry (DSC), and polarized optical microscopy (POM). Linear and nonlinear extrapolation methods have been deployed to estimate the equilibrium melting temperature ( ), which is used for analyzing the supercooling dependence of the PLLA spherulitic growth rate (G). A double-melting behavior observed for PLLA under crystallization Tc < 120 °C has been attributed to the formation of both α′ and α crystals. The values of both α′ and α crystals have been evaluated using the linear method (172.8 °C) and nonlinear method (196.4 °C), with the nonlinear estimate being 23.6 °C higher. A discontinuity in the temperature dependence of spherulite growth rate is observed around 128.3 °C. Regime II–III transition is found to occur at 128.3 °C when = 196.4 °C as estimated by the nonlinear extrapolation method.
3 October 2019 in Journal of Bioactive and Compatible Polymers
Bacterial cellulose holds great promise for tissue engineering, but its application is greatly limited due to the lack of large pores and poor cell affinity. In this study, macroporous bacterial cellulose was fabricated through the dissolution of gelatin microspheres, which were incorporated with bacterial cellulose during bacterial cellulose fabrication. Then, gelatin was immobilized onto bacterial cellulose surface via procyanidins crosslinking. The results confirmed that the scaffolds possessed interconnected macroporous structure, high porosity, good water uptake ability, and good mechanical properties. The results of evaluation of cells showed that cells migrated to the inner of macroporous affinitive bacterial cellulose and displayed better spreading as well as proliferation than that on pure bacterial cellulose surfaces. The macroporous affinitive bacterial cellulose show potential as a scaffold for tissue engineering.
The isothermal crystallization of poly(l-lactide) (PLLA) has been investigated by in-situ wide angle X-ray diffraction (WAXD) and polarized optical microscopes (POM) equipped with a hot-stage accessory. Results showed that the spherulites of PLLA were formed at high temperature, whereas irregular morphology was observed under a low temperature. This can be attributed to the varying rates of crystallization of PLLA at different temperatures. At low temperatures, the nucleation rate is fast and hence the chains diffuse very slow, resulting in the formation of imperfect crystals. On the other hand, at high temperatures, the nucleation rate is slow and the chains diffuse fast, leading to the formation of perfect crystals. The change in the value of the Avrami exponent with temperature further verifies the varying trend in the morphological feature of the crystals.