InGaN-based light-emitting diodes (LEDs) have been widely accepted as highly efficient light sources capable of replacing incandescent bulbs. However, applications of InGaN LEDs are limited to small devices because their fabrication process involves expensive epitaxial growth of InGaN by metalorganic vapor phase epitaxy on single-crystal wafers. If we can utilize a low-cost epitaxial growth process, such as sputtering on large-area substrates, we can fabricate large-area InGaN light-emitting displays. Here, we report the growth of GaN (0001) and InGaN (0001) films on amorphous SiO2 by pulsed sputtering deposition. We found that using multilayer graphene buffer layers allows the growth of highly c-axis-oriented GaN films even on amorphous substrates. We fabricated red, green, and blue InGaN LEDs and confirmed their successful operation. This successful fabrication of full-color InGaN LEDs on amorphous substrates by sputtering indicates that the technique is quite promising for future large-area light-emitting displays on amorphous substrates.
19 December 2003 in Japanese Journal of Applied Physics
In this study, we investigated the basic electrical properties of Si-doped wurtzite GaN films prepared using a low-temperature pulsed sputtering deposition (PSD) process. We found that the electron concentration can be controlled in the range between 1.5 × 1016 and 2.0 × 1020 cm−3. For lightly Si-doped GaN ([Si] = 2.1 × 1016 cm−3), the room temperature (RT) electron mobility was as high as 1008 cm2 V−1 s−1, which was dominantly limited by polar optical phonon scattering. Moreover, we found that heavily Si-doped GaN prepared using PSD exhibited an RT mobility as high as 110 cm2 V−1 s−1 at an electron concentration of 2 × 1020 cm−3, which indicated that the resistivity of this film was almost as small as those of typical transparent conductive oxides such as indium tin oxide. At lower temperatures, the electron mobility increased to 1920 cm2 V−1 s−1 at 136 K, and the temperature dependence was well explained by conventional scattering models. These results indicate that Si-doped GaN prepared using PSD is promising not only for the fabrication of GaN-based power devices but also for use as epitaxial transparent electrode materials for nitride based optical devices.
We have grown Mg-doped GaN films with low residual hydrogen concentration using a low-temperature pulsed sputtering deposition (PSD) process. The growth system is inherently hydrogen-free, allowing us to obtain high-purity Mg-doped GaN films with residual hydrogen concentrations below 5 × 1016 cm−3, which is the detection limit of secondary ion mass spectroscopy. In the Mg profile, no memory effect or serious dopant diffusion was detected. The as-deposited Mg-doped GaN films showed clear p-type conductivity at room temperature (RT) without thermal activation. The GaN film doped with a low concentration of Mg (7.9 × 1017 cm−3) deposited by PSD showed hole mobilities of 34 and 62 cm2 V−1 s−1 at RT and 175 K, respectively, which are as high as those of films grown by a state-of-the-art metal-organic chemical vapor deposition apparatus. These results indicate that PSD is a powerful tool for the fabrication of GaN-based vertical power devices.
We have investigated the growth temperature dependence of the structural properties of GaN deposited on O-polarity ZnO using pulsed laser deposition. We have found that atomically abrupt heterointerfaces are obtained at growth temperatures reduced to below . We have also found that GaN grown at room temperature (RT) exhibits a Ga polarity while that grown at exhibits a N polarity. However, it is possible to grow Ga-polarity GaN at by the introduction of a RT buffer layer. First principles calculations well explain how Ga-polarity GaN may be grown on atomically flat O-polarity ZnO surfaces at low temperatures.
The authors have grown high-quality -plane GaN films on ZnO substrates using pulsed laser deposition. They have found that annealing in a box made of ceramic ZnO improves the surface morphology of -plane ZnO substrates and have succeeded in the layer-by-layer growth of -plane GaN on the annealed ZnO substrates even at room temperature (RT). X-ray diffraction reveals that high crystalline quality -plane GaN grows on the RT buffer layer at . The -thick -plane GaN film grown on the ZnO substrate contains the residual strains because the lattice mismatches between them are quite small. The relationship of in-plane and out-of-plane strains is consistent with the calculation using the elastic constants.