Hiroshi Fujioka

Prof. Dr. Hiroshi Fujioka

Institute of Industrial Science, The University of Tokyo, 504 4-6-1 Komaba, Meguro-ku, Tokyo 153-8505, Japan

Research Focus & Metrics

Academic Career Length

42Years (1985-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 June 2014 in Scientific Reports
Verified
Journal Article
Open access
JSJeong Woo Shon
Jeong Woo Shon
JOJitsuo Ohta
Jitsuo Ohta
KUKohei Ueno
Kohei Ueno
AKAtsushi Kobayashi
Atsushi Kobayashi
Hiroshi FujiokaHiroshi Fujioka
Hiroshi Fujioka
InGaN-based light-emitting diodes (LEDs) have been widely accepted as highly efficient light sources capable of replacing incandescent bulbs. However, applications of InGaN LEDs are limited to small devices because their fabrication process involves expensive epitaxial growth of InGaN by metalorganic vapor phase epitaxy on single-crystal wafers. If we can utilize a low-cost epitaxial growth process, such as sputtering on large-area substrates, we can fabricate large-area InGaN light-emitting displays. Here, we report the growth of GaN (0001) and InGaN (0001) films on amorphous SiO2 by pulsed sputtering deposition. We found that using multilayer graphene buffer layers allows the growth of highly c-axis-oriented GaN films even on amorphous substrates. We fabricated red, green, and blue InGaN LEDs and confirmed their successful operation. This successful fabrication of full-color InGaN LEDs on amorphous substrates by sputtering indicates that the technique is quite promising for future large-area light-emitting displays on amorphous substrates.

7 October 2003 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
JOJ. Ohta
J. Ohta
Hiroshi FujiokaHiroshi Fujioka
Hiroshi Fujioka
MOM. Oshima
M. Oshima
We have grown GaN films on (Mn,Zn)Fe2O4 (111) substrates by pulsed-laser deposition at room temperature and investigated their structural properties using reflection high-energy electron diffraction, atomic force microscopy, grazing-incidence x-ray reflectivity, and grazing-incidence x-ray diffraction (GIXD). We have found that GaN (0001) grows epitaxially even at room temperature. The room-temperature growth of GaN starts with the two-dimensional mode followed by the three-dimensional mode, which indicates that the precursors of GaN have large energy enough to migrate on the surface. GIXD measurements showed that the in-plane epitaxial relationship is GaN [11-20] // (Mn,Zn)Fe2O4 [01-1] and approximately 90% of the lattice mismatch is released at the interface. These results indicate that the present technique solves one of the two major problems with epitaxial growth of GaN (mismatch in the thermal expansion coefficients) and alleviates the other problem (mismatch in the lattice constants).

4 February 2014 in Scientific Reports
Verified
Journal Article
Open access
MOMasaaki Oseki
Masaaki Oseki
KOKana Okubo
Kana Okubo
AKAtsushi Kobayashi
Atsushi Kobayashi
JOJitsuo Ohta
Jitsuo Ohta
Hiroshi FujiokaHiroshi Fujioka
Hiroshi Fujioka
Although the demand for high-speed telecommunications has increased in recent years, the performance of transistors fabricated with traditional semiconductors such as silicon, gallium arsenide, and gallium nitride have reached their physical performance limits. Therefore, new materials with high carrier velocities should be sought for the fabrication of next-generation, ultra-high-speed transistors. Indium nitride (InN) has attracted much attention for this purpose because of its high electron drift velocity under a high electric field. Thick InN films have been applied to the fabrication of field-effect transistors (FETs), but the performance of the thick InN transistors was discouraging, with no clear linear-saturation output characteristics and poor on/off current ratios. Here, we report the epitaxial deposition of ultrathin cubic InN on insulating oxide yttria-stabilized zirconia substrates and the first demonstration of ultrathin-InN-based FETs. The devices exhibit high on/off ratios and low off-current densities because of the high quality top and bottom interfaces between the ultrathin cubic InN and oxide insulators. This first demonstration of FETs using a ultrathin cubic indium nitride semiconductor will thus pave the way for the development of next-generation high-speed electronics.

26 June 2006 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
SIS. Inoue
S. Inoue
KOK. Okamoto
K. Okamoto
NMN. Matsuki
N. Matsuki
TKTae-Won Kim
Tae-Won Kim
Hiroshi FujiokaHiroshi Fujioka
Hiroshi Fujioka
We have grown GaN films on Cu(111) substrates using pulsed laser deposition. We have found that GaN(0001) grows epitaxially on Cu(111) when employing low temperature grown AlN buffer layers with an in-plane epitaxial relationship of AlN[112¯0]‖Cu[11¯0] Reflection high-energy electron diffraction images have exhibited sharp streaky patterns, indicating that GaN grows with a flat surface. Electron backscattering diffraction observations have revealed that neither 30° rotational domains nor cubic phase domains exist in the GaN films. Spectroscopic ellipsometry measurements have shown that the heterointerfaces in the GaN∕AlN∕Cu structure are abrupt. The epitaxial growth of GaN on Cu substrates is likely to raise the power limit for future light emitting and electron devices due to the high thermal conductivity of Cu.

17 July 2006 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
MKM. H. Kim
M. H. Kim
MOM. Oshima
M. Oshima
HKH. Kinoshita
H. Kinoshita
YSY. Shirakura
Y. Shirakura
KMK. Miyamura
K. Miyamura
Hiroshi FujiokaHiroshi Fujioka
Hiroshi Fujioka
We have investigated the initial stage of GaN epitaxial growth on 6H-SiC (0001) at low substrate temperatures by pulsed laser deposition (PLD). We found that GaN grows epitaxially even at room temperature (RT) on atomically flat 6H-SiC (0001) surfaces, which can be explained by the enhanced surface migration of film precursors due to the use of PLD and atomically flat substrates. In situ reflection high-energy election diffraction observations have revealed that GaN films grown at above 300°C proceed in a three-dimensional mode, while those at RT proceed in a layer-by-layer growth mode with atomically flat terraces and steps. The step height turned out to be 1.5nm , which is the same height as the steps on the SiC substrates. This result indicates that the step height on the SiC surface is retained as the GaN grows.

5 May 2014 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
TWT. Watanabe
T. Watanabe
JOJ. Ohta
J. Ohta
TKT. Kondo
T. Kondo
MOM. Ohashi
M. Ohashi
KUK. Ueno
K. Ueno
Hiroshi FujiokaHiroshi Fujioka
Hiroshi Fujioka
GaN films were grown on Si (110) substrates using a low-temperature growth technique based on pulsed sputtering. Reduction of the growth temperature suppressed the strain in the GaN films, leading to an increase in the critical thickness for crack formation. In addition, an AlGaN/GaN heterostructure with a flat heterointerface was prepared using this technique. Furthermore, the existence of a two dimensional electron gas at the heterointerface with a mobility of 1360 cm2/Vs and a sheet carrier density of 1.3 × 1013 cm−2 was confirmed. Finally, the use of the AlGaN/GaN heterostructure in a high electron mobility transistor was demonstrated. These results indicate that low-temperature growth via pulsed sputtering is quite promising for the fabrication of GaN-based electronic devices.