Phospholipid transfer protein (PLTP) participates in high density lipoprotein (HDL) metabolism. Increased plasma PLTP activity was observed in lipopolysaccharide (LPS) triggered acute inflammatory diseases. This study aimed to determine the exact role of PLTP in LPS induced inflammation. HDL pool size was shrunk both in PLTP deficient mice (PLTP−/−) and PLTP transgenic mice (PLTP-Tg). PLTP displayed a strong protective effect on lethal endotoxemia in mice survival study. Furthermore, after LPS stimulation, the expression of pro-inflammatory cytokines were increased in bone marrow derived macrophage (BMDM) from PLTP−/−, while decreased in BMDM from PLTP-Tg compared with BMDM from wild-type mice (WT). Moreover, LPS induced nuclear factor kappa-B (NFκB) activation was enhanced in PLTP−/− BMDM or PLTP knockdown RAW264.7. Conversely, PLTP overexpression countered the NFκB activation in LPS challenged BMDM. Additionally, the activation of toll like receptor 4 (TLR4) induced by LPS showed no alteration in PLTP−/− BMDM. Finally, PLTP could bind to LPS, attenuate the pro-inflammatory effects of LPS and improve the cell viability in vitro. To sum up, these findings elucidated that PLTP repressed LPS induced inflammation due to extracellular LPS binding capability and the protective effects were not related to HDL pool size in mice.
In this paper, an analytical method based on the series transform and skewed slot structure of rotor is adopted to reduce the cogging torque of the variable flux memory permanent magnet (VFMPM) machine. Firstly, the theory analysis of the cogging torque of the VFMPM machine was completed. Secondly, a simulation model of the VFMPM machine was established, aiming at calculating the cogging torque of the VFMPM machine and verifying the correctness of the above analytical method. Thirdly, a prototype of 14 rotor slots and 12 stator slots of the VFMPM machine was manufactured, and the experimental results of the cogging torque of the VFMPM machine further verified the effectiveness of the above mentioned theory analysis. Besides, the load force of the VFMPM machine including the cogging torque was also tested and analyzed in this paper.
Ocean wave height is one of the critical factors to decide the efficiency of the ocean wave energy conversion system. Usually, only when the resonate occurs between the ocean wave height (ocean wave speed in the vertical direction) and ocean wave energy conversion system, can the conversion efficiency from ocean wave energy into electric energy be maximized. Therefore, this paper proposes two predication methods to predict the future ocean wave height in 1.5–2.5 s. Firstly, the data fitting of real ocean wave height is achieved by the polynomial method, which is beneficial to the predication of ocean wave height. Secondly, the models of the moving average (MA) predication method and auto regressive (AR) predication method are presented by the time series analysis process. Lastly, after the predication of ocean wave height by the MA method and AR method, and compared with the data fitting result of real ocean wave height, it can be found that the AR method is more accurate for the predication of ocean wave height. In addition, the predication results also indicated that the error between the predication value and true value in the future 2.5 s is considered acceptable, which provides enough time to optimize the operation process of the ocean wave energy conversion system by a suitable control method.
In this study, the back electromotive force (EMF) waveforms of a flux switching permanent magnet (FSPM) machine and variable flux memory permanent magnet (VFMPM) machine with same main dimension were researched. Firstly, the simulation result showed that the maximum amplitude of phase back EMF waveform of FSPM machine was 245% larger than that of the VFMPM machine, and this was verified by the experimental result (243%). Secondly, the phase back EMF harmonics of the FSPM machine and VFMPM machine were compared, including the enhance flux condition and weaken flux condition of VFMPM machine. At last, the mutual demagnetization effect, which led to the difference amplitudes of maximum back EMF waveform between FSPM machine and VFMPM machine was analyzed. The comparison and analysis of the back EMF waveform will provide some qualitative advice for the future application research of the FSPM machine and VFMPM machine, such as application selection, optimization control method and so on.
In this paper, an ocean wave energy conversion system (OWECS) is modeled and experimented in the Yellow Sea near Lianyungang port, and an optimized control method based on the sliding mode control is proposed to improve the efficiency of OWECS. Firstly, a motion model of a double-buoy OWECS is presented using a complex representation method, and the analysis results indicate that the efficiency of converting ocean wave energy into the outer buoy’s mechanical power is highest in a suitable ocean wave period. Secondly, a double-buoy OWECS is constructed and experimented in the Yellow Sea near Lianyungang port, which verified the correctness of the above analysis results. Lastly, in order to further improve the efficiency of the double-buoy OWECS, a sliding mode control method based on a linear generator is proposed to realize the phase synchronization between the outer buoy and ocean waves, and the simulation results may be beneficial for the next ocean test of the double-buoy OWECS.
Fatigue seriously affects work efficiency and brings potential safety hazards, and electroencephalogram (EEG) serves as a valuable physiological indicator for fatigue monitoring, as it directly reflects underlying brain neural activity. A key characteristic in EEG fatigue research is that the feature spaces of pre-fatigue and post-fatigue EEG signals exhibit obvious spatial separation—this separation is caused by significant changes in brain electrical activity when the human body transitions from a normal awake state to a fatigue state. Existing EEG-based fatigue judgment methods mostly focus on binary classification, which fails to fully leverage the inherent spatial separation characteristic of pre-fatigue and post-fatigue feature spaces, making it difficult to achieve simple, efficient, and accurate fatigue judgment. To address this problem, this paper proposes an EEG fatigue judgment method based on feature space spatial separation and Approximate Nearest Neighbor Search (ANNS). The 16-channel pre-fatigue (Group A) and post-fatigue (Group B) EEG signals acquired from seven subjects are segmented and subjected to feature extraction, projecting the signals into a unified feature space. An ANNS index is constructed using feature vectors from both Group A and Group B, with each vector annotated by its corresponding class label. A separate test set (Group C) is utilized, and the k-nearest neighbors of each test feature vector are retrieved from the built ANNS index. The mental fatigue state is then identified via majority voting according to the class labels of the k-nearest neighbors. Experimental results demonstrate that the proposed method can effectively exploit the spatial separation between pre-fatigue and post-fatigue feature distributions, yielding an average single-subject classification accuracy of approximately 90%.