Oliver Feuchtmüller

Mr. Oliver Feuchtmüller

University of Stuttgart, Institute of Machine Components
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2022 in Lubricants
Verified
Journal Article
Open access
PDF file
Oliver FeuchtmüllerOliver Feuchtmüller
Oliver Feuchtmüller
LHLothar Hörl
Lothar Hörl
FBFrank Bauer
Frank Bauer
A key factor influencing the friction of rod seals is a thin oil film, which is dragged into the sealing gap at outstroke and instroke. Accurate determination of oil film thickness in the sealing gap of rod seals is a challenging task since it is only in the range of a few nanometers. A novel measurement procedure to analyze the friction of common reciprocating sealing systems in direct relation to the shear rate and film thickness is introduced in this paper. Results from a first empirical study with film thicknesses in the range of a few nanometers and shear rates up to γ˙=107 s−1 were used to compare the friction of practically relevant polyurethane U-cups. The U-cups differ in their geometry and surface roughness. It is seen that even at such thin films, the measured friction of those seals can be approximated by Newtonian fluid friction (speed, film thickness, viscosity, contact area). In general, the novel measurement procedure is useful in a scientific and technical context, since it offers a new perspective on tribological mechanisms at thin film lubrication conditions.

16 September 2021 in Lubricants
Verified
Journal Article
Open access
PDF file
Oliver FeuchtmüllerOliver Feuchtmüller
Oliver Feuchtmüller
Nino DakovNino Dakov
Nino Dakov
LHLothar Hörl
Lothar Hörl
FBFrank Bauer
Frank Bauer
The oil film generation of a U-cup rod seal and the oil film thickness on the rod after outstroke were analyzed analytically, numerically, and experimentally. The analyzed sealing system consists of an unmodified, commercially available U-cup, a polished rod, and mineral oil. The inverse theory of hydrodynamic lubrication (IHL) and an elastohydrodynamic lubrication (EHL) model—both based on the Reynolds equation for thin lubricating films—were utilized to simulate the oil film generation. In the EHL analysis, physical parameters and numerical EHL parameters were varied. Both the analytical and numerical results for the varied parameters show that the film thickness follows a square-root function (i.e., with a function exponent of 0.5) with respect to the product of dynamic viscosity and rod speed, also referred to as the duty parameter. In comparison to the analytical and numerical results, the film thickness obtained via ellipsometry measurements is a function of the duty parameter with an exponent of approximately 0.85. Possible causes for the discrepancy between theory and experiments are discussed. A potential remedy for the modeling gap is proposed.

17 October 2022 in Chemical Engineering & Technology
Verified
Journal Article
Open access
Oliver FeuchtmüllerOliver Feuchtmüller
Oliver Feuchtmüller
LHLothar Hörl
Lothar Hörl
FBFrank Bauer
Frank Bauer

1 January 2022
Verified
Conference Paper
Closed access
SBSumbat Bekgulyan
Sumbat Bekgulyan
SFSimon Feldmeth
Simon Feldmeth
Oliver FeuchtmüllerOliver Feuchtmüller
Oliver Feuchtmüller
LHLothar Hörl
Lothar Hörl
FBFrank Bauer
Frank Bauer