Bucket elevators generally operate on a 24/7 basis, and for this reason, one of the main requirements is their high reliability. This reliability can be ensured, among other things, by assessing the technical condition of drive assemblies and working assemblies and taking appropriate measures. Carrying out diagnostic measurements enables periodical monitoring of those mechanisms. Vibroacoustic methods are usually employed in operating conditions to measure vibration velocity and acceleration at specific points, and are used as diagnostic signals. This paper presents the results of tests of the intensity of vibrations generated in the drive unit of a large industrial bucket elevator. The analysis of the results in the time domain and frequency domain served as the basis for evaluating the suitability of the drive, and thus the elevator, for long-term operation.
Failure of systems applied in machines comprising rolling and slewing bearings usually causes downtime of the entire heavy machine. The problem of failures can be aggravated by extremely difficult operating conditions, such as significant loads or a harsh environment. The entire issue inspired us to develop a method of monitoring the condition of such units. A study was carried out for six different large-scale excavators which examined strain distributions in the tested subassemblies. In order to estimate the technical condition of wheeled bogies, we used the phenomenon of strain propagation caused by the concentrated force acting in the ring girder web. Flamant theory was utilized to describe this phenomenon. Measurements were performed using strain gauges and the obtained results were compared with the FEM model. To determine whether bearing joints were in a good or bad condition, a coefficient of variation and an impulse factor were introduced as diagnostic indicators. It turned out that by evaluating these indicators, it was possible to distinguish between these two conditions. The method was successfully validated on machines that are in operation.
This article proposes a method for diagnosing the main systems of bucket elevators in order to ensure their reliable operation. This method employs diagnostic indices of vibration velocity and vibration acceleration, which were deemed useful based on tests performed on four bucket elevators operating in a research laboratory and in a power plant. This article also analyzes other indicators, such as the coefficient of variation, skewness, kurtosis, crest factor, and quantile peak factor, and demonstrates the usefulness of kurtosis for diagnostic evaluation. Additionally, it proposes using the quantile peak factor as an alternative to the crest factor. This study estimates the statistical distributions of diagnostic signals and presents the results in the form of histograms. This is followed by the detection of outliers in all measurement series. Based on the results of the performed tests and their analysis, recommendations are made for diagnosing bucket elevators.
10 March 2019 in Lecture Notes in Mechanical Engineering
The durability of bearing units of large machines depends mainly on the condition of their welded joints. With this in mind, we developed numerical models of the analyzed bearing units, for which we performed FEM simulations of the stresses in welded joints in several basic load cases. In each of the respective variants the technical condition of the bearing nodes was different and it corresponded to the severity of the degradation processes. Different positions of the superstructure in relation to the undercarriage were also taken into account. The simulations used the hot-spot method dedicated to FEM analyses of complex welded structures. We discovered that the loads have a significant influence on the values and distribution of von Mises principal stresses and their axial components. Based on the carried out analyses, we identified the most unfavorable load cases that generate the highest stresses in the welded joints of the assessed nodes. We also demonstrated that the applied method effectively assesses the stresses of welded joints subjected to variable working loads.
Bucket elevators are applied in many industries for bulk material handling. One of the main requirements for these devices is their high operational reliability. This applies in particular to power units that must operate continuously without failure. This article presents a comparative assessment of the drive units of two bucket elevators. The vibration intensity of their bearing units was used as the basis for the comparison. The evaluation was carried out using three independent methods based on the vibration velocity analysis: in the time domain, in the frequency domain and using the probabilistic approach.