It is known that the elastic characteristics of polyamides change with increasing temperature; in particular, the Young’s modulus decreases significantly. This fact is practically not taken into account in design calculations of metal-polymer plain (MP) bearings, operating under conditions of the boundary and dry friction. The purpose of the study was the analysis of the effect of temperature on the change of the Young’s modulus and, accordingly, the contact strength and triboresource according to the developed method of calculating MP bearings. MP bearings with a bushing made of polyamide PA6 reinforced with glass or carbon-dispersed fibers were investigated. Quantitative and qualitative regularities of change of the maximum contact pressures and resource of the bearings at temperature increase under conditions of boundary and dry friction are established. The pressures in the bearing bushing made of PA6 + 30GF will be lower than for the bushing made of PA6 + 30CF. The resource of the bushing made of PA6 + 30CF will be significantly greater than for PA6 + 30GF. For thermoplastic polymers, the increase in temperature will have a useful practical effect due to the decrease in the rigidity of the polymer composites of the bearing bushing.
1 September 2020 in Advances in Science and Technology Research Journal
Calculation methods for predicting the service life of metal-polymer gears with height correction are proposed. Two methods for gear service life estimation are presented: a simplified method that assumes constant tooth interaction conditions and an improved method that takes into account...
This study evaluates the computation method of the study of worm gears with Archimedean and involute worms when engagement correction is presented, based on the contact pressures and the...
An experimental and theoretical method of triboanalysis is proposed to characterize the antifriction properties of polyamides and composites based on them,
Predictive assessments of the performance characteristics of metal-polymer (MP) plain bearings at the design stage are necessary and important for engineering practice. They include assessments of bearing capacity, linear wear of the bushing, and bearing life. However, no method for their calculation has been developed. The authors created a generalized analytical method for the mathematical modeling of MP sliding bearings as a classical science-based method to study the contact mechanics of conformal cylindrical bodies with consideration of polymer bushing wear. The contact problem of the theory of elasticity takes into account the significant difference in the elasticity characteristics of polymeric materials from those of steel: their Young’s modulus is 60–250 times smaller, and Poisson’s ratio is 1.27–1.37 times larger. The method was used to study MP bearings with bushings made from several common groups of tribopolymers: polyamides (PAs), polytetrafluoroethylenes (PTFEs), polyethylene terephthalates (PETs), and polyetheretherketones (PEEKs). The maximum contact pressures and durability of the dry friction bearings were calculated while taking into account the load; radial clearance; bushing thickness; the tribopolymers’ elasticity characteristics and wear resistance; the sliding friction coefficient; and the type of tribopolymer material. The Young’s modulus of a polymer material had a significant impact on the level of maximum contact pressures. Polymer fillers, depending on their type and the type of polymer, had very different effects on pressure changes (increase, no change, or decrease). An increase in pressure caused an increase in contact pressures. The durability of a mechanical bearing depended not only on the contact pressure but also on the polymer’s wear resistance, Young’s modulus, and friction coefficient. This study determined the quantitative and qualitative effects of these factors on the maximum contact pressures and bearing durability. The presented analytical method provides an effective and reasonable assessment of the specified service characteristics of sliding bearings with consideration of the multifactorial influence of the above factors.