Poly(ethylene succinate) (PES) is one of the most promising biodegradable and biocompatible polyesters and is widely used in different biomedical applications. However, little information is available on its solubility and precipitation properties, despite that these solution behavior properties affect its applicability. In order to systematically study these effects, biodegradable and biocompatible poly(ethylene succinate) (PES) was synthesized using ethylene glycol and succinic acid monomers with an equimolar ratio. Despite the optimized reaction temperature (T = 185 °C) of the direct condensation polymerization, relatively low molecular mass values were achieved without using a catalyst, and the Mn was adjustable with the reaction time (40–100 min) in the range of ~850 and ~1300 Da. The obtained crude products were purified by precipitation from THF (“good” solvent) with excess of methanol (“bad” solvent). The solvents for PES oligomers purification were chosen according to the calculated values of solubility parameters by different approaches (Fedors, Hoy and Hoftyzer-van Krevelen). The theta-solvent composition of the PES solution was 0.3 v/v% water and 0.7 v/v% DMSO in this binary mixture. These measurements were also allowed to determine important parameters such as the coefficients A (=0.67) and B (=3.69 × 104) from the Schulz equation, or the Kη (=8.22 × 10−2) and α (=0.52) constants from the Kuhn–Mark–Houwink equation. Hopefully, the prepared PES with different molecular weights is a promising candidate for biomedical applications and the reported data and constants are useful for other researchers who work with this promising polyester.
Herein we present the synthesis of a polymeric prodrug nanomaterial capable of spontaneous, self-assembled nanoparticle formation and of the conjugation (encapsulation) of drugs with amino and/or carboxyl and/or hydroxyl groups via ester and/or amide linkage. Mitomycin C (MMC) a versatile drug with antibiotic, antibacterial and antineoplastic properties, was used to prove this concept. The in vitro drug release experiments showed a fast release for the pure MMC (k = 49.59 h−n); however, a significantly lower MMC dissolution rate (k = 2.25, 1.46, and 1.35 h−n) was obtained for the nanoparticles with increased cross-link density (3, 10, 21%). The successful modification and conjugation reactions were confirmed using FTIR and EDX measurements, while the mucoadhesive properties of the self-assembled particles synthesized in a simple one-pot reaction were proved by rheological measurement. The prepared biocompatible polymeric prodrugs are very promising and applicable as a drug delivery system (DDS) and useful in the area of cancer treatment.