Structural health monitoring (SHM) has gained importance because many structures are approaching the end of their design life and demanding maintenance and monitoring. Low-cost solutions may push forward a widespread implementation of SHM on infrastructures but further investigation is still required to assess the performance of technically accessible, simple, and scalable low-cost systems. This work presents the development and validation of a low-cost vibration-based SHM multinode wireless system, based on the Arduino platform, for identification of modal parameters in civil infrastructures. Full details about the hardware and source code of the system are disclosed in an open repository, allowing its reproduction even by non-specialists in electronics. The sampling frequency stability of the system is experimentally characterized, and interpolation postprocessing algorithms are proposed to solve inherent limitations. The system is validated, and its performance is investigated in impulse and ambient vibration tests performed in a real-scale slab and a high-grade system. The data obtained from the proposed system in impulse tests allowed estimation of natural frequencies within 2%, and MAC values around 0.3 to 0.9, in relation to those estimated with the high-grade system. However, the low-cost system was unable to produce usable data in ambient vibration tests.
The Elastic Modulus Measurement through Ambient Response Method (EMM-ARM) is designed to continuously monitor the elastic modulus of hardening construction materials such as concrete, cement paste, mortars, stabilized soils, and epoxy resin. In practice, a composite beam, made of the tested material in its mould, is induced to vibration by means of environmental or controlled excitation, and its resonant frequency is identified. The material’s elastic modulus can then be calculated based on the vibration equation of structural systems. The traditional system to conduct EMM-ARM experiments is based on specialized equipment and on proprietary licensed software, which results in a considerable cost, as well as limited options for customization. The paper hereby presented proposes a delve into the development and validation of a cost-effective and open-source system that is able to conduct EMM-ARM experiments. By using a Raspberry Pi for the computing device and cost-effective electronic components, the cost of the system was one-twentieth of the traditional one, without compromising the measurement reliability. The composite beam’s excitation is generated, while the vibration response is recorded by the proposed system simultaneously, since the Raspberry Pi supports multiprocessing programming techniques. The flexibility earned by the exclusive use of open-source and cost-effective resources creates countless application possibilities for the proposed system.
Aligned with the world’s tendency of searching for sustainable technologies, the waste addition into materials of the civil construction is an interesting option for wastes that do not have proper destination. This work has the objective of studying the feasibility of incorporating paint waste from furniture painting booth, which currently does not have any correct ecological destination, into covering mortars and investigate if this addition brings any improvement in performance. For this purpose, it was prepared six compositions of covering mortars, with a cement-sand volume proportion of 1:6 and a Flow-table consistency of 260 mm +- 10mm, varying the waste percentage added among the proportions of 0%, 2%, 4%, 6%, 8% and 10% on the cement weight. It was determined, for each composition, the specific gravity and the air-entrained content in the fresh stage. For physical tests, it was moulded nine prismatic samples and one mortar substrate for the bond tensile strength test per mortar composition. It was determined the flexural and compressive strength in the hardened stage, the specific gravity, the water absorption coefficient due to capillary action and the bond tensile strength. Leaching tests were performed for environmental analysis of the mortars produced with waste addition. It was observed that all the mortars with waste received a similar classification to the mortar without waste, according to NBR 13281 [], and the leaching tests showed that mortars with waste were not ecologically dangerous, demonstrating the feasibility of the incorporation. In addition, mortars produced with waste presented an increase in the entrained air percentage, which might be a beneficial action of the paint waste.